K.E.W Service & Repair Forum

Hi, Help please, i\'m in need of a new lance for my older Kew Hobby 2600, would you have this item in stock ?

— Posted by David Kerr on 2009-06-12

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "K.E.W"

If you need your K.E.W unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 95 Comments

#K.E.W by Chris bolton on 2009-07-10 15:22
My Kew is not building up pressure can you tell me why please
➡️ Reply
#K.E.W by Garry S James on 2009-04-09 10:26
I have a KEW 1502V – Hot & Cold Pressure Washer. I will be running this of a Generator at the same time as a water pump which has a rating of 700w.1. Can you what is the start up current of the Pressure Washer.2. What size Generator should I be looking for to run the Pressure Water and the Water Pum…...
Show More
➡️ Reply
#K.E.W by john farkas on 2011-10-26 18:47
For any KEW products call Chris Gerber in S.C. (877)322-2586. Very knowledgable and helpfull. He is the US service rep.
➡️ Reply
#K.E.W by lyndon hammill on 2006-11-06 19:24
All the lights on the temp gauge lit means that the fuel tankis empty. If there is fuel in the tank, there may not be enoughto activate the tank sensor. put more fuel in.If the tank is full,the tank sender is faulty. It will need replacing.In the meentime you can bypass the tank sender by shorting o…...
Show More
➡️ Reply
#K.E.W by Blair on 2007-08-15 01:10
call windy city equipment located in Elgin, Illinois
➡️ Reply
#K.E.W by ken Tucker on 2008-05-01 16:53
My KEW 1502v-66 is smoking badly and does not get hot. I think the diesel is not burning right. There is a blue flame between the contacts.
➡️ Reply
#K.E.W by AUSTIN GIBBONS on 2010-03-30 14:40
CAN I BUY A SPARE PART FOR THE ABOVE, IE, THE PRESSURE WASHER AT THE END OF THE LANCE.?WITH THANKS AUSTIN GIBBONS
➡️ Reply
#K.E.W by gary case on 2010-09-23 15:00
we can\'t get water flow through the machine
➡️ Reply
#K.E.W by larry on 2009-03-26 07:25
need to find out how to change the unit from 110 volts to 220 volts. thanks
➡️ Reply
#K.E.W by Richard Lane on 2008-12-24 11:32
HelloI have a kew 1502 steam cleaner which has a problem with the burner. It will run for about 5 seconds then cut out, I have changed the diesel filter and cleaned the filter into the nozzle. Also I have checked that the electrodes are working properly. Its as if something is turning the diesel sup…...
Show More
➡️ Reply
#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09
Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5
➡️ Reply
#K.E.W by thijs thissen on 2009-07-13 08:11
We have recently purchased an second hand KEW high pressure cleaner but it does not get the full cleaning pressure. Can I recieve an owners manual by email to see what parts may be broekn in order to fix the machine?Thank you in advance.best regards,Thijs.
➡️ Reply
#K.E.W by Adrian Frost on 2011-05-16 11:17
Hi, I have a KEW Steam Cleaner model 16A2V-66 Year 1986. I bought it from a company asset auction and never saw it working. I have now tried to use it and the temperature lights reached the temperature set once, then the burner went out and would not re-light. I dissconnected the fuel supply to the …...
Show More
➡️ Reply
#K.E.W by dan johnson on 2007-05-28 23:54
I am trying to find out any info on this Kew (0802v-56)steam washer. If someone has a manual available, that would be great.
➡️ Reply
#K.E.W by mario yasin on 2012-12-04 21:44
i need to fix my pei kew 4503kb pumbe kit and throtecan you fix itthank you
➡️ Reply
#K.E.W by Scott A Wilson I on 2012-07-24 12:43
Hi there.I have A Kew steam cleaner model #0802v-56 And would like to see about getting these manual\'s for this cleaner . Please and thank you . Scott
➡️ Reply
#K.E.W by Tom Duclos on 2016-05-31 14:22
Need transformer for above unit part number #3819901 can you help me..
➡️ Reply
#K.E.W by EdwardKn on 2015-03-27 17:20
Hello. And Bye.
➡️ Reply
#K.E.W by Richard Beck on 2009-05-25 21:04
Have a Kew 3803V pressure washer, need to know where I can get itrepaired nearby.thank you
➡️ Reply
#K.E.W by JAMES FARMER on 2016-05-02 19:22
the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?
➡️ Reply
#K.E.W by Owen Torgerson on 2012-03-22 19:12
Great machine, had since new, recently experiencing difficulties acquiring heat.Lots of kerosene, lots of pressure on cold, new fuel spray nozzle...Help
➡️ Reply
#K.E.W by hans on 2009-05-13 16:54
i can\'t get pressure on my kew 1640H. But i have seen that there are watercristals in the pressuremeter. Does someone know what the problem is?Thanks
➡️ Reply
#K.E.W by Brent C. on 2012-10-02 22:26
No fuel getting to burner, need manual for test procedure. Thank you, Brent C.
➡️ Reply
#K.E.W by MARK on 2010-01-02 19:00
My kew steam cleaner does not have water pressure. It exits the gun but only trickles out. Can you help? Many thanksMark
➡️ Reply
#K.E.W by holmeside garage lee scott on 2012-02-13 22:01
i have a kew 1640ha which i am having a bit trouble with reacently when whent to use it it cum up with the fault L1 and now the machine will not start,i was wundering if you could give me a bit help THANKS
➡️ Reply
#K.E.W by Martin Ferguson on 2009-07-10 14:10
No comments
➡️ Reply
#K.E.W by mohammed zaki on 2015-03-30 11:01
HelloPlease can you inform me where i can repair my washing machinemodel (5203k) in united arab emitares.Thanks @ Best Regards
➡️ Reply
#K.E.W by Anthony blair rowland on 2012-06-04 19:58
Please can you help i have a kew 1502v it will run fine cold, as soon as i demand heat it runs for 5 seconds and switches off if you switch it on & off,it runs for 5seconds and it will do this all day. what is the solution please
➡️ Reply
#K.E.W by Hassan. Mortazavi on 2010-10-10 01:05
How do i test the electrod or egniter to see its good?Thanks
➡️ Reply
#K.E.W by Ruth Montefiore on 2010-03-15 13:33
The black hose pipe connected to this pressure washer has a whole in it. Can it be repaired and if so how please. If not how much will it cost to desptach a replacement to me or where can I purchase this hose pipe? Is it something I can obtain from a builders merchants and if so what size please?I l…...
Show More
➡️ Reply
#K.E.W by Arvid Hartsuiker on 2008-11-11 18:15
Front seal on pump leaking, looking for parts to repair and repair manual. Please give me a call or email. Thanks Arvid
➡️ Reply
#K.E.W by PAUL GALLAGHER on 2008-11-17 21:50
HI,I HAVE JUST PURCHASED A KEW 38A2VA POWER WASHER. IS IT POSSIBLE TO GET A MANUAL FOR THIS MACHINE? ALSO WHAT GOES IN THE TANK MARKED WITH A SNOWFLAKE?THANKS PAUL.
➡️ Reply
#K.E.W by Bodengien on 2017-12-18 08:27
HelloBought a secand hand KEW38A2VA and overhauld and cleanend the machine. The boiler doesnt start however. Can I get a manual for the machine ?? Thanks in advance. Bodengien.
➡️ Reply
#K.E.W by maria helena on 2010-03-17 22:12
i need manual for kew 1640ha
➡️ Reply
#K.E.W by Murray Smith on 2010-10-09 06:33
I need a instruction manual for a KEW 1502-66 thank you
➡️ Reply
#K.E.W by Jesus on 2019-10-11 08:59
Hi I have a KEW 1502v and some body stolen parts so I put all back together but for any reason it not working the heater and I suspected it about the wiring position, and the pressure is stopping and not keep spraying and some times work fine but some times not, one time I fix only with a new clamp …...
Show More
➡️ Reply
#K.E.W by brian breslin on 2009-10-14 19:43
where might I download a user manual for parts and maintenance of my 1640h Thanks Brian
➡️ Reply
#K.E.W by J.den Dekker on 2011-04-03 06:34
Geachte meneer/mevrouw,Ik heb heb kew 1500 hogedruk spuitpart nr. 6137219 Serial nr. 6998760.Kunt u mij vertellen of ik een terrascleaner kan krijgen voor deze hogedruk spuit en als dat mogelijk is kunt u mij vertellen waar en wat hij kost.vr.gr.J.den Dekker
➡️ Reply
#K.E.W by LIMANI on 2010-08-08 21:44
guten abent icsh bin limani cshaban aus macedonia icsh brauche eine tail for meine macshine das chaist pumpe for k.e.w.1502 iat mit drei klipen un federen und kenzi zaigen prais bite
➡️ Reply
#K.E.W by ken williams on 2011-11-08 03:02
Hi would you have a service manual for this cleaner??
➡️ Reply
#K.E.W by William Knee on 2009-03-21 12:25
HI I check all and no start and I am a Electrician
➡️ Reply
#K.E.W by Ulf Dahl on 2015-03-24 13:14
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!Uffe
➡️ Reply
#K.E.W by ryan on 2011-04-02 17:51
I have a 1979 kew power washer and am looking for some pump parts or info on where to get parts it is mostly all in good shape put the pump needs work any info would be greatly apresated thanks ryan
➡️ Reply
#K.E.W by angelineadlecraft@gmail.com on 2019-05-02 14:02
Good dayI am trying to find a manual to assist me with the heating system of a K.E.W. 38A2VA.Many thanks
➡️ Reply
#K.E.W by Serge on 2013-06-13 13:06
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!
➡️ Reply
#K.E.W by REYGAN on 2008-11-06 11:58
my steam cleaner 1640h is showing alarm F1 could anybody help me to find out the reason or send me manual of this machine thanksreygan bernard
➡️ Reply
#K.E.W by Antonio Gonzalez on 2012-06-19 13:41
need the service manual of KEW 01K pressure washer
➡️ Reply
#K.E.W by Josh Campbell on 2005-10-26 14:14
I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I …...
Show More
➡️ Reply
#K.E.W by Clifford Brown on 2010-10-10 03:46
I still do not have all the details of what this machine is, but it appears to be a hot water pressure washer.. Would be interested in the instructions manual to see if I can get it going. Do not have all of the ID place numbers copied down yet though. The copper windings for the boiler look good fr…...
Show More
➡️ Reply
#K.E.W by KEIRON on 2008-04-03 18:18
my steam cleaner is flashing F1 light, does anyone know what this fault is and does anyone have a manuel for this model?many thanks
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.