Navico Service & Repair Forum

I'm reaching out for repair service for my Navico JB 8000 controller unit. The issue I'm experiencing is that the unit fails to power on or respond to any input commands. I've tried troubleshooting by checking the power source and connections, but the problem persists. Based on my assessment, the estimated replacement cost for a new Navico JB 8000 controller is approximately $200-$300. I would appreciate any assistance in diagnosing and resolving the issue to avoid the cost of purchasing a new unit. Thank you for your

— Posted by Liliana Hernandez on 2009-04-07

Reply🗨️Ask a New Question Below❓

If you need your Navico unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 3 Comments

#Navico by Alena on 2005-02-16 00:00
Experiencing erratic compass readings on my Navico HS 8000 unit. Need assistance diagnosing and resolving the issue
➡️ Reply
#Navico by Liliana Hernandez on 2009-04-07 10:26
I'm reaching out for repair service for my Navico JB 8000 controller unit. The issue I'm experiencing is that the unit fails to power on or respond to any input commands. I've tried troubleshooting by checking the power source and connections, but the problem persists. Based on my assessment, the es...
Show More
➡️ Reply
#Navico by Shaun Condon on 2013-11-18 00:00
Navico E01142 control board malfunctioning, showing error codes and not responding to inputs. Need repair ASAP to minimize downtime.
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.