Ondyne Inc Service & Repair Forum

Hello, I have a model 2100 Ondyne hygrometer with sensor that needs calibration. This instrument is used in a dry/glove box seam sealer. Compared to another hygrometer that just came back from calibration, the ondyne reads about 10°C higher, -45°C compared to -54°C read by the KAHN Cermet II that i just received back from cal. The ondyne has not been out for cal in many years and suspect the sensor is getting saturated. If you can service this model, do you suggest exchanging the sensor or servicing the meter and sensor both? If this is something you can support please send an emailed quote to my attention. If you need more information please let me know. Thank you, Randy Lenox, Sr. Metrologist, API Technologies/Spectrum Microwave, State College, PA. PH# Cell: 321-298-1368. Thank you again.

—> Purchase or Repair: Ticket Image

— Posted by Randy Lenox on 2013-04-14

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Ondyne Inc"

If you need your Ondyne Inc unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110

Recent 2 Comments

#Ondyne Inc by Mike Collins on 2007-02-13 14:37
can you repair a 2000ANNV ? we normally do our own calibration and repairs, but this unit fails calibration and we have not found any data on it. the write up indicates the sensor is not functioning properly and a film was found on the sensor. I should be able to get more information later.can you r…Purchase or Repair: Ticket Image...
Show More
➡️ Reply
#Ondyne Inc by Randy Lenox on 2013-04-14 21:23
Hello, I have a model 2100 Ondyne hygrometer with sensor that needs calibration. This instrument is used in a dry/glove box seam sealer. Compared to another hygrometer that just came back from calibration, the ondyne reads about 10°C higher, -45°C compared to -54°C read by the KAHN Cermet II that i …Purchase or Repair: Ticket Image...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.