Procond Elettronica Service & Repair Forum
Experiencing issues with Procond Elettronica MC-70 124438 treadmill board. Need a skilled technician to repair an industrial unit immediately. Thank you.
—> Purchase or Repair:
Reply🗨️Ask a New Question Below❓
Recent Comments Search: "Procond Elettronica"
- Procond Elettronica → Procond Elettronica MC-70 141914 ↗
- Procond Elettronica → AMF Paragon Timer ↗
- Procond Elettronica → MC-70 AW.REV- PART#124438 ↗
- Procond Elettronica → MC-70 Motor Controller ↗
- Procond Elettronica → Procond Elettronica MC-70 124438 ↗
- Procond Elettronica → Procond Elettronica MC-70 MOTOR CONTROLLER ↗
- Procond Elettronica → Procond Elettronica device to create PWM ↗
- Procond Elettronica → Procond Elettronica MC-70 motor controller ↗
- Procond Elettronica → Procond Elettronica my mc 70 board sent in for repair ↗
- Procond Elettronica → Procond Elettronica Procond Elettronica MC-70 Repair-THANKS ↗
- Procond Elettronica → Thanks ↗
- Procond Elettronica → MC-70 AW Rev - motor controller for Image 10.6Q ↗
- Procond Elettronica → Procond Elettronica 45220051 675807501 ↗
If you need your Procond Elettronica unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110
Recent 569 Comments
One of the Procond Elettronica MC-70 124438 treadmill controllers is displaying unusual behavior in the warehouse.
—> Purchase or Repair:
—> Purchase or Repair:
Please provide an update on the status of the repair for my Procond Elettronica MC-70 124438 treadmill board. It is still not functioning, and I require assistance immediately.
—> Purchase or Repair:
—> Purchase or Repair:
Please repair and tesT under load for satisfactory operation. Believe burn out at DZ1, dz4a, dz4b LOCATION ON BOARD.
—> Purchase or Repair:
—> Purchase or Repair:
The treadmill IMAGE 10.6Q has the KEY missing.Can you please provide us the Key or recommendwhere I will be able to get it.Thanks
—> Purchase or Repair:
—> Purchase or Repair:
Procond Elettronica MC-70 124438 treadmill controller not functioning, slowing down production line. Urgent repair service needed to resolve issue
—> Purchase or Repair:
—> Purchase or Repair:
Elevation motor is working properly, drive motor does not starts.There are 2 diods that are burn: DZ1 and DZ4 (in between the relay and what look like to be 2 ceramic resistors). There is an overheat area on PCB under these diods, but PCB still OK.Would you sell me just the diods?If not, how should …Purchase or Repair: 
...
Show More
Show More
Hi,Please quote your repair, exchange or refurbished unit prices for Procond Elettronica controller PN 141877 used in a Proform 830 treadmill.Thanks,Peter
—> Purchase or Repair:
—> Purchase or Repair:
HelloIs it possible to have a schematic or technical datasheet of this module :Type P 451510061 F:6210Type E 12430392/7SW ver W2C013T2 31/01BEST REGARDS
—> Purchase or Repair:
—> Purchase or Repair:
Hi there, we have a Procond Elettronica MC-70 124438 treadmill controller that needs repair. Can you provide repair information or suggest where we can find a replacement part? Thank you.
—> Purchase or Repair:
—> Purchase or Repair:
The treadmill controller board on Procond Elettronica MC-70 124438 is malfunctioning, disrupting production. Urgent repair service needed to address the issue
—> Purchase or Repair:
—> Purchase or Repair:
NEED BOARD MACHINE INSTALLED IN A CARRIER AIR CONDITIONER BRAND MODEL:GE ELECTRONIC PROCOND 356,068,908.YOU CAN DELIVER IN THE U.S. EVEN VIA FEDEX?OUR CUSTOMER WILL BE IN THE USA next week.PLS WAIT RETURN.CLÓVIS HIROSHI KUNII
—> Purchase or Repair:
—> Purchase or Repair:
Hello, I am interested in purchasing a Procond Elettronica MC-70 124438 treadmill controller. I would like to inquire about the pricing and availability of this unit. I am looking to source one quickly. Thank you.
—> Purchase or Repair:
—> Purchase or Repair:
How can I get circuit diagram with block for this circuit board?There are two large fuse type resistors or right hand side of board, what are they? Looks like they are burned. What are the reasons for this overheated ?
—> Purchase or Repair:
—> Purchase or Repair:
Hello, I have a Procond Elettronica MC-70 124438 treadmill board that needs replacement or repair. It's an older unit, and we're unsure of the manufacturer. Could you please advise if this model is still supported or if replacement parts are available? Thank you.
—> Purchase or Repair:
—> Purchase or Repair:
Procond Elettronica MC-70 motor controller is malfunctioning, causing a complete halt in production. Urgent repair service needed to resume operations immediately.
—> Purchase or Repair:
—> Purchase or Repair:
I need chasis mounted filter type efnf 3,in indonesia maybe semarang..please info to pay,tq
—> Purchase or Repair:
—> Purchase or Repair:
Machine error Error code E5 displayed on Procond Elettronica MC-70 124438 treadmill board.
—> Purchase or Repair:
—> Purchase or Repair:
The board in the Procond Elettronica MC-70 124438 treadmill controller has failed, needs replacement ASAP. Please order a new one to ensure timely repair.
—> Purchase or Repair:
—> Purchase or Repair:
ARE YOU GUYS BUY USED BOARDS PULLED FROM TREADMILLSIF SO HOW MUCH NOT TESTED? OR REPAIRED, UNLESS YOU WANTED THEM REPAIRED
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica 452200190 KK88102678 board is malfunctioning, causing a halt in the production line. Urgent repair is needed to resume operations immediately.
—> Purchase or Repair:
—> Purchase or Repair:
The treadmill board on Procond Elettronica MC-70 124438 is malfunctioning, affecting the production line. Please address this issue urgently to resume operations
—> Purchase or Repair:
—> Purchase or Repair:
I am following up on the previous message regarding the Procond Elettronica MC-70 124438 treadmill board. The unit is still down. We need assistance with this matter as soon as possible. Please reply
—> Purchase or Repair:
—> Purchase or Repair:
the Procond Elettronica MC-70 124438 treadmill board on unit X is malfunctioning. Needs attention ASAP. Please check it out first thing in the morning. Thanks!
—> Purchase or Repair:
—> Purchase or Repair:
AEC Electrolux fridge freezer circuit board has burnt out part no GE ITA:452707180 sw NFBFOA24 :20/054225. can you advise cost of replacement and delivery time please.
—> Purchase or Repair:
—> Purchase or Repair:
Good afternoon, I`m looking for a module Procond Elettronica 3560089039 for a washdisher Fagor, and also the price.Thank you very much.
—> Purchase or Repair:
—> Purchase or Repair:
The red light is all the time flashing, when the the compressor first comes on it stays on for good 5-10 min and goes to standby and then when it comes back on after a while it stays on for round about 3 min and there about . The supper freeze dose not come on as well, so i will be very great full i…Purchase or Repair: 
...
Show More
Show More
HelloIm also would like to test this my module, i don\'t know if it\'s working well Is it possible to have a schematic or technical datasheet of this module *******Waht is the cost for repair? What is the cost for a new one?GE Procond ElettronicaType P. 451510051 Type E. 12430392/5SW Ver. W2C01250 2…Purchase or Repair: 
...
Show More
Show More
Would anyone be so kind and send me an circuit diagram for Procond Elettronica board n. 3560033089 many thanksBernd
—> Purchase or Repair:
—> Purchase or Repair:
R57 resistance value is 1k ohms wire wound around 5watts. presently i am looking for the value of R68. can you help?sanjay
—> Purchase or Repair:
—> Purchase or Repair:
The treadmill board on the Procond Elettronica MC-70 124438 is malfunctioning, disrupting the production line. Urgent repair service is needed to restore operations
—> Purchase or Repair:
—> Purchase or Repair:
The treadmill controller for the Procond Elettronica MC-70 124438 is malfunctioning, impacting production. Urgent attention and repair service are needed to resolve this issue swiftly.
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill controller is displaying error code E4, indicating a motor speed sensor malfunction.
—> Purchase or Repair:
—> Purchase or Repair:
Hellol Need schematic for procond elettronika 3560144029 or information about ferrite transformer (voltage winding or equivalent resistance)thank you
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica 356033305 47-90 circuit board is displaying Error Code E304 intermittently, preventing the equipment from powering up. Please advise on troubleshooting steps ASAP. Thank you.
—> Purchase or Repair:
—> Purchase or Repair:
Dear Sirs, I have a PROCOND ELETTRONICA card damaged.It is inside the yellow cover with these codesTYPE: 452604120COD ZANUSSI: 15248541/0220/240 Vac - 50 Hz T65 Ver. AWK 27/00The ELECTRONIC CARD inside damaged is marked:GE PROCOND ELETTRONICA 356084500The processor assembled on the card is marked SI…Purchase or Repair: 
...
Show More
Show More
Hi,We have a defect controller board : \"3560144009\" from Procond Elettronica.It fails by periodically stops the motor and heating elements. It seems that the ignition for the motor is unstable. For me it sounds like it is a moped / motorcycle with a bad ignition :-)Please could you inform me what …Purchase or Repair: 
...
Show More
Show More
Hey there. Treadmill controller (Procond Elettronica MC-70 124438) malfunctioned mid-shift. Need someone to check it out ASAP during the day. Thanks!
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill board is malfunctioning, causing a halt in the production line. Urgent repair service is required to resume operations without further delay.
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill controller unit went down mid-shift. Please check and troubleshoot
—> Purchase or Repair:
—> Purchase or Repair:
I'm reaching out to inquire about the support and availability of replacement parts for the Procond Elettronica MC-70 124438 treadmill controller. It is an older unit, and we are uncertain about the manufacturer. Please advise if this model is still supported or if replacement parts are available. T…Purchase or Repair: 
...
Show More
Show More
Procond Elettronica MC-70 124438 treadmill controller displaying error code E05, preventing treadmill function.
—> Purchase or Repair:
—> Purchase or Repair:
Hello, can zou give me a price for follow boardType P. 451510050Type E. 12430392/4SW Ver. W2C01202ThanksbrMarc Schmuck
—> Purchase or Repair:
—> Purchase or Repair:
The treadmill board on the Procond Elettronica MC-7012 124438 is malfunctioning, affecting the production line. Urgent repair service needed to resolve the issue
—> Purchase or Repair:
—> Purchase or Repair:
I have a Procond Elettronica MC-70 124438 treadmill controller that needs repair. The treadmill is not responding when turned on. Looking for a qualified technician to fix it as soon as possible.
—> Purchase or Repair:
—> Purchase or Repair:
—> Purchase or Repair: