Rytec Service & Repair Forum

We just installed 3 Rytec Predadors with the Feig Encoders , 1 Door worked fine 2 do not have communications with the controler. Rytec support claims the wire is bad , we replaced the wire but left it at full lenght with no change , the door that works has the full lenght of cable thus making me believe there is something more that we are missing , by the way we also swapped encoders with brand new units , is there a problem that these units have that Rytec is not aware of or not willing to disclose.

— Posted by Wayne Medeiros on 2011-06-03

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Rytec"

If you need your Rytec unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110

Recent 5 Comments

#Rytec by David Salata on 2015-09-22 20:41
Model DG1200 Rytec Do you work on these?Can you estimate cost and turn around time?Thanks. You worked on an Atlas Copco controller ....still works !!
➡️ Reply
#Rytec by Rick Martin on 2009-11-18 07:51
I have a TCP-101 Rytec roll-up door control unit that has a shorted power input. Can you give a ball-park estimate for repair? No rush, I have a spare. Sorry, but due to spammers my email is generic until I decide to work with you.
➡️ Reply
#Rytec by Don Reed Bonita Packing on 2009-09-03 18:03
I just replaced the control board on a RYTEC High Speed roll up door. Rytec doesn\'t offer a repair service for the board I removed and I\'m looking for that service.
➡️ Reply
#Rytec by Ghislain Dufour on 2011-03-31 11:44
we have here a rytec control board and search for somewhere to have it fixedthanks for the support.
➡️ Reply
#Rytec by Wayne Medeiros on 2011-06-03 23:40
We just installed 3 Rytec Predadors with the Feig Encoders , 1 Door worked fine 2 do not have communications with the controler. Rytec support claims the wire is bad , we replaced the wire but left it at full lenght with no change , the door that works has the full lenght of cable thus making me bel…...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.