Sanyo Denki Service & Repair Forum
Sir,i am using sanmotion TS1-AA2AA for sanmotion servo motor.this a fully programmable drive.the main problem i am facing with this one is iam enabling the servo on function any time.but the servois not switched means 140v to the drive is not going.please tell me the solution,regardsSreekanth reddy.C
—> Purchase or Repair:
Reply🗨️Ask a New Question Below❓
Recent Comments Search: "Sanyo Denki"
- Sanyo Denki → Sanyo Denki Pdt 803 20 Servo ↗
- Sanyo Denki → manualS ↗
- Sanyo Denki → .75 kw sanyodenki servomotor encoder reg. ↗
- Sanyo Denki → About san motion motor ↗
- Sanyo Denki → PM Driver Repair. ↗
- Sanyo Denki → Sanyo Denki SANMOOTION- motor repairing ↗
- Sanyo Denki → Sanyo Denki PY2A015A2 ↗
- Sanyo Denki → Sanyo Denki PM driver ↗
If you need your Sanyo Denki unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110
Recent 8 Comments
we have amplifier sanyo denki make1.60BA100FFW0H2.60BA030FXW0T3.60BA030FXW0PPLEASE HELP US IN GETTING CONNECTING MANUALSREPLY SOON
—> Purchase or Repair:
—> Purchase or Repair:
sir,our cnc m/c brother tcs2a table axis servomotor (sanyo denki) having position shifting error is facing because of encode got detororated due to coolant entry. is it possibe to change the encoder , if it is possible please guide me.thanks®ardss.sankar
—> Purchase or Repair:
—> Purchase or Repair:
Hi,I have few (around 5) PM Driver (Model: PMAPA1A6B20) units that failed while used at TEL Prober Machine. The part age is 3-4 years.Usually the problem reflects as noisy motor and motion followed by encoder errors. What will the common repair cost for that?Best regardsNir Ben-hur972-54-3339535—> …Purchase or Repair: 
...
Show More
Show More
Dear sir I am using PM driver (sanyo denki PMM-MD-23120-10) for stepper motor (sanyo denki 103H71121-0410). As I selected pulse/direction mode the motor runs in CW direction only when I down the direction pin low. The output of PC4 is high when its input is low. what is wrong with PM driver ?rgdsSan…Purchase or Repair: 
...
Show More
Show More
We still need assistance with the Sanyo Denki PY2A015A2 Servo Drive. Urgent action is required to get the unit back up and running. Your
—> Purchase or Repair:
—> Purchase or Repair:
We have one equipment in which sanmotion motor is used for motion and now gone bad. we want to repair this motor. Symptoms:- Armature jam, Tight in motion.Model no:- Q1AA06040DXS24MMake:-Sanyo Denki.Please reply soon.
—> Purchase or Repair:
—> Purchase or Repair:
Show More