The Shop saidIs the resistor missing from the unit or just open/burnt? If missing or color codes unreadable then we would just draw a schematic of the surrounding circuits and figure out the correct value. If the resistor is open/burnt then cut it in half and remove the metal caps at the end being sure to leave the other metal cap on the end, be careful you only get 1 shot at this. Then measure the resistance from the end to middle and you will be in the ballpark by one of the 2 pieces. If you can't figure it out then send the unit to us.Thanks
—> Purchase or Repair:
If you need your Smith Geosource unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.
—> Purchase or Repair: