Systron-Donner Service & Repair Forum

The 4 amp fuse on the small power supply board keeps blowing.This causes the display to be inoperable. I checked the currentthrough this fuse, and found that it was 1.62 amps, in an idlemode (unit not doing anything except sitting there, turned on).What could be causing this to blow the fuses (weak, bad component,etc. ??)Thanks Cordially, Terry Thero

— Posted by Terry Thero on 2008-10-15

Reply🗨️Ask a New Question Below❓

If you need your Systron-Donner unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 3 Comments

#Systron-Donner by MIJATOVIC Milos on 2008-02-06 11:11
Hi,I would like to know if you could repair a Systron Donner 1730B generator (26.5GHz) ?Please send me an email rather than calling me as my spoken english is quite bad.
➡️ Reply
#Systron-Donner by Girbal Ray on 2008-02-07 12:04
Dear sir, plz send me you reired you post
➡️ Reply
#Systron-Donner by Terry Thero on 2008-10-15 17:39
The 4 amp fuse on the small power supply board keeps blowing.This causes the display to be inoperable. I checked the currentthrough this fuse, and found that it was 1.62 amps, in an idlemode (unit not doing anything except sitting there, turned on).What could be causing this to blow the fuses (weak,...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.