Versapply Service & Repair Forum

HI, I have a Versapply labeler and its in good shape and it was working ok but someone screwed with the controls on the circuit board ( AX915033P ) and I can\'t seem to get it synced with the prduct on the conveyer. It sometimes spits out three labels instead of one. We are atempting to use it on a single wrapped cookie 4\" by 4\" and 1/2 inch thick . Would you have any drawings or instruction on what pots does what to the delay etc. There are several on the board. I also have adjustments on the product sensor Sunx CX- PRVM3. Any help would be greatly appreciated. Are there any download sites for instructions on setup you know of for this vintage of Varsapply? Thanks and God Bless America, Don

— Posted by Don Page on 2008-03-24

Reply🗨️Ask a New Question Below❓

If you need your Versapply unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 4 Comments

#Versapply by Jose Luis Bravo on 2006-05-02 13:31
Please be so kind to quote: Two pieces of part number AX915034P Board Driver for Versaply Label MachineThanks so much
➡️ Reply
#Versapply by Don on 2008-02-26 23:15
HI, I have a versapply 9100R-40 that has been in storgae for a while. We would like to attempt to use it but we have no operators manual , schematic diagrams or anything to work with. Do you have any liturature to help. We are willing to pay for it. We also have a 77 Doboy supermustang wrapper we ar...
Show More
➡️ Reply
#Versapply by Don Page on 2008-03-24 23:38
HI, I have a Versapply labeler and its in good shape and it was working ok but someone screwed with the controls on the circuit board ( AX915033P ) and I can\'t seem to get it synced with the prduct on the conveyer. It sometimes spits out three labels instead of one. We are atempting to use it on a ...
Show More
➡️ Reply
#Versapply by Craig James Titzkowski on 2011-07-09 06:47
I need to know how to get replace ment parts and a manual that shows the parts so I can order the part I need that would be of great help. I work maintenance for Trident Seafood\'s and am just doing some tracking down of info for my Chief. So we can order parts we need
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.