Procond Elettronica Service & Repair Forum
The Procond Elettronica MC-70 124438, which serves as the treadmill controller, experienced a malfunction earlier today, causing unexpected downtime from 230 PM to 445 PM. I'm seeking a brief explanation before the next shift comes in. Thank you.
—> Purchase or Repair:
Reply🗨️Ask a New Question Below❓
Recent Comments Search: "Procond Elettronica"
- Procond Elettronica → Procond Elettronica MC-70 124438 ↗
- Procond Elettronica → Procond Elettronica MC-70 141914 ↗
- Procond Elettronica → MC-70 AW Rev - motor controller for Image 10.6Q ↗
- Procond Elettronica → Procond Elettronica MC-70 MOTOR CONTROLLER ↗
- Procond Elettronica → MC-70 Motor Controller ↗
- Procond Elettronica → Procond Elettronica MC-70 motor controller ↗
- Procond Elettronica → Procond Elettronica Procond Elettronica MC-70 Repair-THANKS ↗
- Procond Elettronica → Thanks ↗
- Procond Elettronica → Procond Elettronica 45220051 675807501 ↗
- Procond Elettronica → AMF Paragon Timer ↗
- Procond Elettronica → Procond Elettronica my mc 70 board sent in for repair ↗
- Procond Elettronica → MC-70 AW.REV- PART#124438 ↗
- Procond Elettronica → Procond Elettronica device to create PWM ↗
If you need your Procond Elettronica unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110
Recent 569 Comments
I would like to thank the people and Industrial Electronic Repair for repairing a mc-70 motor control boad. I was working on an elderly couples treadmill and found the control board defective, when I contacted Industrial I explained how they were elderly and didn\'t have a lot of money. Industrial o…Purchase or Repair: 
...
Show More
Show More
The Procond Elettronica MC-70 124438 treadmill board is malfunctioning, causing a hold-up in the production line. Immediate repair service is needed to resume operations.
—> Purchase or Repair:
—> Purchase or Repair:
I am following up on my previous message regarding the Procond Elettronica MC-70 124438 treadmill controller. The unit is still down. Please provide assistance
—> Purchase or Repair:
—> Purchase or Repair:
Please provide an update on the status of my Procond Elettronica MC-70 124438 treadmill controller. It is still not working, and I need a response
—> Purchase or Repair:
—> Purchase or Repair:
I am in need of the schematic for MC-70 AW.Rev -, Motor Control, P/N: 124438. Apprearantly, Zener diode, DZ1 and diode D10 were damaged. Does anyone know where I can get it? Thank you very much.Best Regards,Tim Dong
—> Purchase or Repair:
—> Purchase or Repair:
Print number: 3560101029Is mounted in Brandt refrigeratorNormal function in about 8 years, then it start writiing "e" in display, and start bipping. Then I turn the temperature up and down, and then it have normal function again, maybe in 1 hour, sometimes 14 days I think its a´failure in …Purchase or Repair: 
...
Show More
Show More
One of the Procond Elettronica MC-70 124438 treadmill controllers is displaying unusual behavior in the warehouse.
—> Purchase or Repair:
—> Purchase or Repair:
DEAR SIRS,COULD YOU TELL ME THE PRICE FOR A PROCOND ELETTRONICA PART NO. 411624430.MANY REGARDS KEVIN
—> Purchase or Repair:
—> Purchase or Repair:
I have a problem with a motor controler for waching machines, and i wanted you to help me about this. It has not enough force to roll the clothes. I changewd the chip, but it is still not working properly. The code: 3 560 332 06
—> Purchase or Repair:
—> Purchase or Repair:
Please provide an update on the status of the repair for my Procond Elettronica MC-70 124438 treadmill board. It is still not functioning, and I require assistance immediately.
—> Purchase or Repair:
—> Purchase or Repair:
My dishwasher Ariston LSI 61 E has broken down.Please How Much cost the board sended to Italy in caserta.Thanks
—> Purchase or Repair:
—> Purchase or Repair:
Ronco Scrivia, 06/09/2011Vi sarei grato se poteste inviarmi preventivo di spesa ed eventuale indirizzo di spedizione per la riparazione della scheda in oggetto.Ringrazio anticipatamente.Gian Piero Traverso
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill controller is malfunctioning - it is not functioning as usual and is showing erratic behavior.
—> Purchase or Repair:
—> Purchase or Repair:
I am a business customer contacting you regarding my Procond Elettronica 356033305 circuit board. The unit seems to be malfunctioning as it is unable to power on or function properly. There are no visible signs of damage or any other external issues that may have caused this problem. I suspect there…Purchase or Repair: 
...
Show More
Show More
I am following up on the previous message regarding the Procond Elettronica MC-70 124438 treadmill board. The unit is still down. We need assistance with this matter as soon as possible. Please reply
—> Purchase or Repair:
—> Purchase or Repair:
Can the Procond Elettronica MC-70 124438 treadmill controller be repaired or replaced? I'm working on crossing this off my to-do list.
—> Purchase or Repair:
—> Purchase or Repair:
Hi, I\'ve a faulty Procond Elettronicatransformer for a switching power supply.The label says \"Procond Elettronica 411070276\"and the case is green.Can you help me in finding a replacement part ?ThanksCristian
—> Purchase or Repair:
—> Purchase or Repair:
I need DZ1 and DZ24 diodes. Both appear to be burned. Can I repair them? Thanks.
—> Purchase or Repair:
—> Purchase or Repair:
R57 resistance value is 1k ohms wire wound around 5watts. presently i am looking for the value of R68. can you help?sanjay
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill board is displaying unusual behavior in the warehouse.
—> Purchase or Repair:
—> Purchase or Repair:
Procond Elettronica MC-70 motor controller is malfunctioning, causing a complete halt in production. Urgent repair service needed to resume operations immediately.
—> Purchase or Repair:
—> Purchase or Repair:
Elevation motor is working properly, drive motor does not starts.There are 2 diods that are burn: DZ1 and DZ4 (in between the relay and what look like to be 2 ceramic resistors). There is an overheat area on PCB under these diods, but PCB still OK.Would you sell me just the diods?If not, how should …Purchase or Repair: 
...
Show More
Show More
Hi, I'm reaching out on behalf of my client regarding a Procond Elettronica MC-70 124438 treadmill board that needs repair. Can you please provide information on the repair process and cost estimation for this specific part? Thank you.
—> Purchase or Repair:
—> Purchase or Repair:
Can the Procond Elettronica MC-70 124438 treadmill board be repaired or replaced? I'm looking to check this off my to-do list.
—> Purchase or Repair:
—> Purchase or Repair:
Depending on the version you have....DZ2 = 3.9V 1/2Watt (replace with higher wattage)DZ1 = 15V 1 watt (replace with 5 watt)DZ4 = 24V 5 watt-OR-New versions haveDZ4A and DZ4B = 12v 5 watt eachResistor is 1K, I replaced it with a 10Watt wire wound 5%.
—> Purchase or Repair:
—> Purchase or Repair:
Hello, I am a business customer seeking repair service for my Procond Elettronica MC-70 124438 treadmill board. The unit is exhibiting an issue where it fails to power on despite being connected to a power source. I have attempted to reset the unit multiple times without success. Based on initial di…Purchase or Repair: 
...
Show More
Show More
Could you please confirm if the Procond Elettronica 356033305 47-90 circuit board is still supported or if replacement parts are available for this older unit? Thank you.
—> Purchase or Repair:
—> Purchase or Repair:
Hello, I am interested in purchasing a Procond Elettronica MC-70 124438 treadmill controller. Could you please provide information on pricing and availability? I am trying to source one quickly. Thank you.
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill board in the warehouse is displaying unusual behavior - it is not functioning as it normally does.
—> Purchase or Repair:
—> Purchase or Repair:
I would like to request a schematic or technical datasheet of Ref =Type Procon :451511360Type E.Z: 13200353/2SW ver USA0020515/00 T70THANKS A LOTBEST REGARDS
—> Purchase or Repair:
—> Purchase or Repair:
Hi,Please quote your repair, exchange or refurbished unit prices for Procond Elettronica controller PN 141877 used in a Proform 830 treadmill.Thanks,Peter
—> Purchase or Repair:
—> Purchase or Repair:
A large amount of people looking for a new job are unsure expediting veteran resume services constitutes a solid investment and this is a excellent puzzle, so we ought to first take a look at some of the every-day finishes that Commenced with executives that make the contract and use a on-the-ball r…Purchase or Repair: 
...
Show More
Show More
Hi there wonder if you can help me find and price, a pcb for a zanussi washing machine, FJS 1425w Prod no 914512721Serial no 10400034Type P6348639IPX4PleaseRegards mike
—> Purchase or Repair:
—> Purchase or Repair:
Hello, the Procond Elettronica MC-70 124438 treadmill controller is still not functioning. Please address this issue
—> Purchase or Repair:
—> Purchase or Repair:
NEED BOARD MACHINE INSTALLED IN A CARRIER AIR CONDITIONER BRAND MODEL:GE ELECTRONIC PROCOND 356,068,908.YOU CAN DELIVER IN THE U.S. EVEN VIA FEDEX?OUR CUSTOMER WILL BE IN THE USA next week.PLS WAIT RETURN.CLÓVIS HIROSHI KUNII
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill board is not working as reported.
—> Purchase or Repair:
—> Purchase or Repair:
The treadmill controller (Procond Elettronica MC-70 124438) is malfunctioning, causing a halt in production. Immediate repair service is required to get the line moving again swiftly.
—> Purchase or Repair:
—> Purchase or Repair:
What are the replacement for DZ1 and DZ4 on the MC-70 board. I am looking for a p/n for DZ1 and DZ4. This will fixed my Mc-70I figure out DZ4 to be a zener diode 24V, 25mA, 1.5W and got a replacement zener diode 24V, 50mA, 5W but I do not know about DZ1. I need info on DZ1 zener diode voltage, and c…Purchase or Repair: 
...
Show More
Show More
Hello, could you please provide repair information for a Procond Elettronica MC-70 124438 treadmill controller? Thank you for your quick response.
—> Purchase or Repair:
—> Purchase or Repair:
Hi, I need a display on the Fagor refrigerator 07-0992440circuit board barcode180809506006manufacturerProcond Elettronica
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill controller is displaying error code E-2, preventing the treadmill from function. Kindly advise on immediate troubleshooting steps. Thank you.
—> Purchase or Repair:
—> Purchase or Repair:
dir : mr ple give me a ELETTONIC CRD [ 3560 041 10 a] 0030-0013c cirkite diagram mr: Ruwinda E/N hotel blue woter sri lanka
—> Purchase or Repair:
—> Purchase or Repair:
One of the drives or boards on the Procond Elettronica MC-70 124438 treadmill controller just failed, please check it out ASAP.
—> Purchase or Repair:
—> Purchase or Repair:
The Procond Elettronica MC-70 124438 treadmill board is displaying unusual behavior in the warehouse. It's not functioning as it normally does.
—> Purchase or Repair:
—> Purchase or Repair:
Looking for someone to repair a Procond Elettronica MC-70 124438 treadmill controller. Not working, need fixing asap.
—> Purchase or Repair:
—> Purchase or Repair:
—> Purchase or Repair: