Sauer Danfoss Service & Repair Forum

Hello, I would like to report an issue with my Sauer Danfoss MC300 AT225288 controller. The unit is not powering on properly. Upon attempting to turn it on, there is no response or display on the screen. I have checked the power source, and it seems to be functioning correctly. Additionally, all connections appear to be secure. I suspect there may be an internal issue with the controller. I would like to inquire about repair services for this unit and request an estimate for the replacement cost. Thank you in advance for your assistance.

— Posted by abel rodriguez on 2019-09-23

Reply🗨️Ask a New Question Below❓

If you need your Sauer Danfoss unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 4 Comments

#Sauer Danfoss by Jesus Arango on 2005-03-24 00:00
Repeat Issues with Sauer Danfoss MC300 AT322362 ControllerHi ,I wanted to bring to your attention that we have been receiving multiple returns or reports regarding the Sauer Danfoss MC300 AT322362 Controller. It seems to be a recurring issue based on what we have observed on paper and what our techn...
Show More
➡️ Reply
#Sauer Danfoss by Dave S. on 2014-11-17 11:38
The Sauer Danfoss 1090256 AT223281 controller is experiencing an issue where it fails to power on and does not respond to any input commands. It may need diagnostics and a potential component replacement, with an estimated cost of replacement being on the higher side due to the specialized nature of...
Show More
➡️ Reply
#Sauer Danfoss by abel rodriguez on 2019-09-23 20:13
Hello, I would like to report an issue with my Sauer Danfoss MC300 AT225288 controller. The unit is not powering on properly. Upon attempting to turn it on, there is no response or display on the screen. I have checked the power source, and it seems to be functioning correctly. Additionally, all con...
Show More
➡️ Reply
#Sauer Danfoss by satish on 2023-06-09 00:00
Experiencing programming issues with Sauer Danfoss MC300 AT304821 controller, unable to initialize settings properly. Need assistance with reconfiguring the programming setup
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.