Dear,


TE-TE Plast is a company specialized for the production of moulds for plastics, pressure die casting tools,
as well as for the production of plastic and batches of parts from steel and aluminum.

We have machine for type FAHR BUCHER SGA60/127.

Because we have a problem (defect) on that machine I want to ask about your opinion for the problem.
Description of the defect:
During the closing of the tool have slow downing, and after that is activate valve Y1. When the tool will close
fully is activating sensor S2.1, but we don’t have exclusion of valve Y1 and receiving increase pressure, for
tension of the tool, because will not activate the valve Y2, but cycle continue to work with slower pressures and
speeds in automation regime.

Input and output cards, are OK, but we are doubt in inccorection of the micro-proccesing card, in which are
e-prom memories and where are written the software programs. The card have mark E6110-063-11 (or
E6110-LP63H II) and it is on the position connector 5.

Also on the screen don’t show any defect of alarm, because don’t increase the high pressure on tension of the
tool. Only once time, after tens checks show information: “RAM oder PROM defekt: Kundendienst anrufen App.28”.

Can you give us your opinion for the defect, and if is possible to buy from you this card with appropriate program.


Also we want to inform you, that in the machine have another identical card that is position the connector 20.
Code switch on the both cards are identical position on the both cards.

We don’t have electrical scheme for conection the cards, so we don’t know for what is use that card.


Thank you very much for your attention.

I hope that you can tell us some information about our problem, or guide how to solve the defect.

Thank you again,
And I expect your answer and e-mail.

Best regards