K.E.W Service & Repair Forum

I am looking for a seal kit for the pump on this unit if you can get one please email me back.

β€” Posted by Tim on 2009-09-28

ReplyπŸ—¨οΈAsk a New Question Below❓


Recent Comments Search: "K.E.W"

If you need your K.E.W unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110

Recent 95 Comments

#K.E.W by REYGAN on 2008-11-06 11:58
my steam cleaner 1640h is showing alarm F1 could anybody help me to find out the reason or send me manual of this machine thanksreygan bernard
➑️ Reply
#K.E.W by Chris bolton on 2009-07-10 15:22
My Kew is not building up pressure can you tell me why please
➑️ Reply
#K.E.W by Serge on 2013-06-13 13:06
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!
➑️ Reply
#K.E.W by Tom Hamilton on 2009-12-16 22:16
I may have the same pressure washer you have. My pressure gauge shows two circular pressure scales. The outer scale is from 0 to 150 with a heavy mark at the 50 digit and 100 digit. At the bottom it says \"BAR\". If your information plate says 62 BAR as mine does then acceptable pressure is between …...
Show More
➑️ Reply
#K.E.W by mark on 2014-10-21 13:50
hi could you tell me where I would get service manual for kew 1640hathanks mark
➑️ Reply
#K.E.W by Ulf Dahl on 2015-03-24 13:14
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!Uffe
➑️ Reply
#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09
Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5
➑️ Reply
#K.E.W by Richard Lane on 2008-12-24 11:32
HelloI have a kew 1502 steam cleaner which has a problem with the burner. It will run for about 5 seconds then cut out, I have changed the diesel filter and cleaned the filter into the nozzle. Also I have checked that the electrodes are working properly. Its as if something is turning the diesel sup…...
Show More
➑️ Reply
#K.E.W by Joe Duran on 2008-06-13 23:41
Can I find a manual ?I was given one of these to me by a customer. I think I need a special water hose??
➑️ Reply
#K.E.W by Hassan Mortazavi on 2010-10-08 16:23
i just got a used ke w scorpian steam cleaner and everything works exept it does not ignite or no spark to get flame.any idea.thankshassan
➑️ Reply
#K.E.W by Blair on 2007-08-15 01:10
call windy city equipment located in Elgin, Illinois
➑️ Reply
#K.E.W by J.den Dekker on 2011-04-03 06:34
Geachte meneer/mevrouw,Ik heb heb kew 1500 hogedruk spuitpart nr. 6137219 Serial nr. 6998760.Kunt u mij vertellen of ik een terrascleaner kan krijgen voor deze hogedruk spuit en als dat mogelijk is kunt u mij vertellen waar en wat hij kost.vr.gr.J.den Dekker
➑️ Reply
#K.E.W by Brent C. on 2012-10-02 22:26
No fuel getting to burner, need manual for test procedure. Thank you, Brent C.
➑️ Reply
#K.E.W by cindy janeski on 2009-05-28 18:35
I am looking for a shop that carries replacement parts for a KEW pressure washer, the hose has sprung a leak and need to replace it the spray nozzle is also attached to the hose as a all in one unit
➑️ Reply
#K.E.W by dan lucas on 2013-03-13 22:08
hi i brought this k.e.w h1500 steam cleaner some year ago,i put it away after it was working ok over 12month ago.i lent it to my brother and it will not pressure up.....his any one out there i can ring to get parts so i can fix it thx 07779666678
➑️ Reply
#K.E.W by maria helena on 2010-03-17 22:12
i need manual for kew 1640ha
➑️ Reply
#K.E.W by TOBY ANDERSON on 2014-08-15 17:47
I have a kew alto 2340ha Everything was working and the usint up and quit It showed a 0 flashing and I unplougged it and put it back it reset to solid 0 but when you push the power on it does nothing. I let sit unplugged but nothing works now. Is there anyone who works on these anymore I am in Wisco…...
Show More
➑️ Reply
#K.E.W by brian breslin on 2009-10-14 19:43
where might I download a user manual for parts and maintenance of my 1640h Thanks Brian
➑️ Reply
#K.E.W by PAUL GALLAGHER on 2008-11-17 21:50
HI,I HAVE JUST PURCHASED A KEW 38A2VA POWER WASHER. IS IT POSSIBLE TO GET A MANUAL FOR THIS MACHINE? ALSO WHAT GOES IN THE TANK MARKED WITH A SNOWFLAKE?THANKS PAUL.
➑️ Reply
#K.E.W by Antonio Gonzalez on 2012-06-19 13:41
need the service manual of KEW 01K pressure washer
➑️ Reply
#K.E.W by William Knee on 2009-03-21 12:25
HI I check all and no start and I am a Electrician
➑️ Reply
#K.E.W by Tom Duclos on 2016-05-31 14:22
Need transformer for above unit part number #3819901 can you help me..
➑️ Reply
#K.E.W by KEIRON on 2008-04-03 18:18
my steam cleaner is flashing F1 light, does anyone know what this fault is and does anyone have a manuel for this model?many thanks
➑️ Reply
#K.E.W by Gary on 2009-06-07 19:47
The burner won\'t turn off can anyone help
➑️ Reply
#K.E.W by ken Tucker on 2008-05-01 16:53
My KEW 1502v-66 is smoking badly and does not get hot. I think the diesel is not burning right. There is a blue flame between the contacts.
➑️ Reply
#K.E.W by frank welch on 2010-12-02 13:46
just want to know how old this machine is and if it can still be repaired,i have no knowledge of what year it was made and know of no place to get it repaired
➑️ Reply
#K.E.W by Dale on 2009-04-08 00:10
Hi, put a oring kit in pump an still get only tap pressure everything looks good ,keyway on pump motor fine. any ideas. Thanks,
➑️ Reply
#K.E.W by Len on 2009-10-23 14:28
I have a copy of the users instruction book for this machine if you are still in need.
➑️ Reply
#K.E.W by Arvid Hartsuiker on 2008-11-11 18:15
Front seal on pump leaking, looking for parts to repair and repair manual. Please give me a call or email. Thanks Arvid
➑️ Reply
#K.E.W by Stuart on 2008-08-09 08:20
I need a service manual for a KEW 1502-66 with exploded views, parts lists with prices... thank you for your time and help with this problem..
➑️ Reply
#K.E.W by marcondes on 2010-03-17 22:11
my machine stop work hot water and pressure no good work
➑️ Reply
#K.E.W by Anthony blair rowland on 2012-06-04 19:58
Please can you help i have a kew 1502v it will run fine cold, as soon as i demand heat it runs for 5 seconds and switches off if you switch it on & off,it runs for 5seconds and it will do this all day. what is the solution please
➑️ Reply
#K.E.W by steve oiveros on 2011-06-20 23:33
I need a parts schematic so I could repair the pump I need the seals kit.
➑️ Reply
#K.E.W by shaban limani on 2011-07-02 17:12
JA ICSH BIN LIMANI CSHABAN ICSH BRAUCHE EINE PUMP MACSHINE FOR AUTO VACSH MACSHINE IST FOR MARKE K.E.W 1502V ICSH CHAP MACSHINE ABER PUMP IST KAPUT BITEIN MAINE EMAIL CSHIKENSI DI VORT FOR MAINE RESPEKT
➑️ Reply
#K.E.W by mario yasin on 2012-12-04 21:44
i need to fix my pei kew 4503kb pumbe kit and throtecan you fix itthank you
➑️ Reply
#K.E.W by Adrian Frost on 2011-05-16 11:17
Hi, I have a KEW Steam Cleaner model 16A2V-66 Year 1986. I bought it from a company asset auction and never saw it working. I have now tried to use it and the temperature lights reached the temperature set once, then the burner went out and would not re-light. I dissconnected the fuel supply to the …...
Show More
➑️ Reply
#K.E.W by steve oliveros on 2011-06-24 22:12
i need a parts list so i could repair the pump
➑️ Reply
#K.E.W by Raymond Cooper on 2007-12-19 04:18
I need a service manual for a KEW 4503KB with exploded views, parts lists with prices... thank you for your time and help with this problem..Raymond Cooper951-926-5394
➑️ Reply
#K.E.W by EdwardKn on 2015-03-27 17:20
Hello. And Bye.
➑️ Reply
#K.E.W by Jeff Osborn on 2009-11-23 21:46
I have recently acquired a K.E.W. Pressure washer and am trying to find information about it. It appears to be from Denmark and in the Model box it just says Hobby. Another box on the ID plate says 62 bar. The gauge on the machine reads 0 to 150 and on the face of the dial it says X 1000. THAT WOULD…...
Show More
➑️ Reply
#K.E.W by sandy stevens on 2009-09-28 13:03
Is there anyway to get a takedown of the pump on my kew steam cleaner the model # 08022-56? A parts book would be good.
➑️ Reply
#K.E.W by Garry S James on 2009-04-09 10:26
I have a KEW 1502V – Hot & Cold Pressure Washer. I will be running this of a Generator at the same time as a water pump which has a rating of 700w.1. Can you what is the start up current of the Pressure Washer.2. What size Generator should I be looking for to run the Pressure Water and the Water Pum…...
Show More
➑️ Reply
#K.E.W by Owen Torgerson on 2012-03-22 19:12
Great machine, had since new, recently experiencing difficulties acquiring heat.Lots of kerosene, lots of pressure on cold, new fuel spray nozzle...Help
➑️ Reply
#K.E.W by dan johnson on 2007-05-28 23:54
I am trying to find out any info on this Kew (0802v-56)steam washer. If someone has a manual available, that would be great.
➑️ Reply
#K.E.W by BoΕΎe Gudelj on 2021-01-28 20:56
KEW 1502 V-66 user manual , service manual
➑️ Reply
#K.E.W by Martin Ferguson on 2009-07-10 14:10
No comments
➑️ Reply
#K.E.W by jonas hofer on 2010-03-14 22:44
I need an instruction manual for a KEW 1640H When i put power to it, it just shut\'s off after two seconds, and i have to reset it. A sign in the small screen say\'s, P1 and F1 i don\'t know what they mean.
➑️ Reply
#K.E.W by Bodengien on 2017-12-18 08:27
HelloBought a secand hand KEW38A2VA and overhauld and cleanend the machine. The boiler doesnt start however. Can I get a manual for the machine ?? Thanks in advance. Bodengien.
➑️ Reply
#K.E.W by Ron on 2010-10-12 02:52
My coil froze last winer when heater broke in shop over weekend , do you have any coils
➑️ Reply
#K.E.W by Hartono on 2011-10-19 06:46
Dear AllPlease give me the information about Services center KEW 0901V In indonesia , for your best cooperation i would to say many thanks
➑️ Reply

Contact Us

πŸš‘Shop LocationπŸ› οΈ

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
πŸš‘ Rush repair shipments only β€” no walk-ins.

πŸ“žPhone

1-336-969-0110

πŸ“¦Mailing AddressπŸš›

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
πŸ“¦ Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.