K.E.W Service & Repair Forum

i need a parts list so i could repair the pump

— Posted by steve oliveros on 2011-06-24

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "K.E.W"

If you need your K.E.W unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 95 Comments

#K.E.W by Ron on 2010-10-12 02:52
My coil froze last winer when heater broke in shop over weekend , do you have any coils
➡️ Reply
#K.E.W by ryan on 2011-04-02 17:51
I have a 1979 kew power washer and am looking for some pump parts or info on where to get parts it is mostly all in good shape put the pump needs work any info would be greatly apresated thanks ryan
➡️ Reply
#K.E.W by leo on 2012-10-14 09:11
DO YOU HAVE A SOLUTION FOR THE OIL VALVE FROM THE BURNERIT WILL NOT GO ON BY WORKING WITH THE MACHINEPRESSION KONTAKTS ARE OKE
➡️ Reply
#K.E.W by Joe Duran on 2008-06-13 23:41
Can I find a manual ?I was given one of these to me by a customer. I think I need a special water hose??
➡️ Reply
#K.E.W by Len on 2009-10-23 14:28
I have a copy of the users instruction book for this machine if you are still in need.
➡️ Reply
#K.E.W by Jesus on 2019-10-11 08:59
Hi I have a KEW 1502v and some body stolen parts so I put all back together but for any reason it not working the heater and I suspected it about the wiring position, and the pressure is stopping and not keep spraying and some times work fine but some times not, one time I fix only with a new clamp …...
Show More
➡️ Reply
#K.E.W by lyndon hammill on 2006-11-06 19:24
All the lights on the temp gauge lit means that the fuel tankis empty. If there is fuel in the tank, there may not be enoughto activate the tank sensor. put more fuel in.If the tank is full,the tank sender is faulty. It will need replacing.In the meentime you can bypass the tank sender by shorting o…...
Show More
➡️ Reply
#K.E.W by Owen Torgerson on 2012-03-22 19:12
Great machine, had since new, recently experiencing difficulties acquiring heat.Lots of kerosene, lots of pressure on cold, new fuel spray nozzle...Help
➡️ Reply
#K.E.W by Tom Hamilton on 2009-12-16 22:16
I may have the same pressure washer you have. My pressure gauge shows two circular pressure scales. The outer scale is from 0 to 150 with a heavy mark at the 50 digit and 100 digit. At the bottom it says \"BAR\". If your information plate says 62 BAR as mine does then acceptable pressure is between …...
Show More
➡️ Reply
#K.E.W by PAUL GALLAGHER on 2008-11-17 21:50
HI,I HAVE JUST PURCHASED A KEW 38A2VA POWER WASHER. IS IT POSSIBLE TO GET A MANUAL FOR THIS MACHINE? ALSO WHAT GOES IN THE TANK MARKED WITH A SNOWFLAKE?THANKS PAUL.
➡️ Reply
#K.E.W by Blair on 2007-08-15 01:10
call windy city equipment located in Elgin, Illinois
➡️ Reply
#K.E.W by shaban limani on 2011-07-02 17:12
JA ICSH BIN LIMANI CSHABAN ICSH BRAUCHE EINE PUMP MACSHINE FOR AUTO VACSH MACSHINE IST FOR MARKE K.E.W 1502V ICSH CHAP MACSHINE ABER PUMP IST KAPUT BITEIN MAINE EMAIL CSHIKENSI DI VORT FOR MAINE RESPEKT
➡️ Reply
#K.E.W by JAMES FARMER on 2016-05-02 19:22
the fuel will not pump, I don`t have the voltage coming out of the oil area of the board to open the solenoid on the fuel pump. I need a schematic to trace the problem, is there one available ?
➡️ Reply
#K.E.W by Rudy Martens on 2009-10-28 06:19
I need a operation manual for KEW 1502v-66
➡️ Reply
#K.E.W by larry on 2009-03-26 07:25
need to find out how to change the unit from 110 volts to 220 volts. thanks
➡️ Reply
#K.E.W by hans on 2009-05-13 16:54
i can\'t get pressure on my kew 1640H. But i have seen that there are watercristals in the pressuremeter. Does someone know what the problem is?Thanks
➡️ Reply
#K.E.W by Josh Campbell on 2005-10-26 14:14
I am trying to refurbish a kew 1502v-66 power washer. I cannot get the oil fired burner to kick on. The control panel has a digital temp gauge and it shows the temperature of the water at its maximum value when the water is cold. I am in question if this is the problem with the burner not firing. I …...
Show More
➡️ Reply
#K.E.W by dan johnson on 2007-05-28 23:54
I am trying to find out any info on this Kew (0802v-56)steam washer. If someone has a manual available, that would be great.
➡️ Reply
#K.E.W by CESAR ALCAZAR on 2011-04-18 14:09
Hi I have a Heated Pressure Washer, and Im lookin for a specific part can you tell me if ispossible to found it. Lelow information of the machineMAKER: KEWMODELL: 3803V-103SER:2103205ASSET:43-1-5
➡️ Reply
#K.E.W by brian breslin on 2009-10-14 19:43
where might I download a user manual for parts and maintenance of my 1640h Thanks Brian
➡️ Reply
#K.E.W by EdwardKn on 2015-03-27 17:20
Hello. And Bye.
➡️ Reply
#K.E.W by mark on 2014-10-21 13:50
hi could you tell me where I would get service manual for kew 1640hathanks mark
➡️ Reply
#K.E.W by Adrian Frost on 2011-05-16 11:17
Hi, I have a KEW Steam Cleaner model 16A2V-66 Year 1986. I bought it from a company asset auction and never saw it working. I have now tried to use it and the temperature lights reached the temperature set once, then the burner went out and would not re-light. I dissconnected the fuel supply to the …...
Show More
➡️ Reply
#K.E.W by sandy stevens on 2009-09-28 13:03
Is there anyway to get a takedown of the pump on my kew steam cleaner the model # 08022-56? A parts book would be good.
➡️ Reply
#K.E.W by Richard Beck on 2009-05-25 21:04
Have a Kew 3803V pressure washer, need to know where I can get itrepaired nearby.thank you
➡️ Reply
#K.E.W by Arvid Hartsuiker on 2008-11-11 18:15
Front seal on pump leaking, looking for parts to repair and repair manual. Please give me a call or email. Thanks Arvid
➡️ Reply
#K.E.W by gary case on 2010-09-23 15:00
we can\'t get water flow through the machine
➡️ Reply
#K.E.W by LIMANI on 2010-08-08 21:44
guten abent icsh bin limani cshaban aus macedonia icsh brauche eine tail for meine macshine das chaist pumpe for k.e.w.1502 iat mit drei klipen un federen und kenzi zaigen prais bite
➡️ Reply
#K.E.W by Antonio Gonzalez on 2012-06-19 13:41
need the service manual of KEW 01K pressure washer
➡️ Reply
#K.E.W by ken Tucker on 2008-05-01 16:53
My KEW 1502v-66 is smoking badly and does not get hot. I think the diesel is not burning right. There is a blue flame between the contacts.
➡️ Reply
#K.E.W by Ruth Montefiore on 2010-03-15 13:33
The black hose pipe connected to this pressure washer has a whole in it. Can it be repaired and if so how please. If not how much will it cost to desptach a replacement to me or where can I purchase this hose pipe? Is it something I can obtain from a builders merchants and if so what size please?I l…...
Show More
➡️ Reply
#K.E.W by William Knee on 2009-03-21 12:25
HI I check all and no start and I am a Electrician
➡️ Reply
#K.E.W by ali on 2009-05-31 05:45
I\'m looking for the maintenance manual for this machine
➡️ Reply
#K.E.W by frank welch on 2010-12-02 13:46
just want to know how old this machine is and if it can still be repaired,i have no knowledge of what year it was made and know of no place to get it repaired
➡️ Reply
#K.E.W by TOBY ANDERSON on 2014-08-15 17:47
I have a kew alto 2340ha Everything was working and the usint up and quit It showed a 0 flashing and I unplougged it and put it back it reset to solid 0 but when you push the power on it does nothing. I let sit unplugged but nothing works now. Is there anyone who works on these anymore I am in Wisco…...
Show More
➡️ Reply
#K.E.W by john farkas on 2011-10-26 18:38
I am looking a the circuit board for my 0840HA hot water pressure washer. Mine burned out, the rest of the machine is nearly new. It would be a shame to trash it. KEW no longer makes this board.
➡️ Reply
#K.E.W by swordcrown sevices on 2008-08-02 22:17
we have a KEW steam cleaner,not sure of age,trolley mounted, recent purchase, but not working.is there anybody out there who can help us, with regards to diagrams, or any possible imformation, perhaps we can then decide on further age, model etc , your help would be greatly appreciated.Yours sincere…...
Show More
➡️ Reply
#K.E.W by Six B Construction on 2008-10-02 15:28
I need a operation manuel for K.E.W. 3803V-103
➡️ Reply
#K.E.W by Dale on 2009-04-08 00:10
Hi, put a oring kit in pump an still get only tap pressure everything looks good ,keyway on pump motor fine. any ideas. Thanks,
➡️ Reply
#K.E.W by Gary on 2009-06-07 19:47
The burner won\'t turn off can anyone help
➡️ Reply
#K.E.W by jonas hofer on 2010-03-14 22:44
I need an instruction manual for a KEW 1640H When i put power to it, it just shut\'s off after two seconds, and i have to reset it. A sign in the small screen say\'s, P1 and F1 i don\'t know what they mean.
➡️ Reply
#K.E.W by ken williams on 2011-11-08 03:02
Hi would you have a service manual for this cleaner??
➡️ Reply
#K.E.W by Hassan. Mortazavi on 2010-10-10 01:05
How do i test the electrod or egniter to see its good?Thanks
➡️ Reply
#K.E.W by Richard Lane on 2008-12-24 11:32
HelloI have a kew 1502 steam cleaner which has a problem with the burner. It will run for about 5 seconds then cut out, I have changed the diesel filter and cleaned the filter into the nozzle. Also I have checked that the electrodes are working properly. Its as if something is turning the diesel sup…...
Show More
➡️ Reply
#K.E.W by Hassan Mortazavi on 2010-10-08 16:23
i just got a used ke w scorpian steam cleaner and everything works exept it does not ignite or no spark to get flame.any idea.thankshassan
➡️ Reply
#K.E.W by holmeside garage lee scott on 2012-02-13 22:01
i have a kew 1640ha which i am having a bit trouble with reacently when whent to use it it cum up with the fault L1 and now the machine will not start,i was wundering if you could give me a bit help THANKS
➡️ Reply
#K.E.W by AUSTIN GIBBONS on 2010-03-30 14:40
CAN I BUY A SPARE PART FOR THE ABOVE, IE, THE PRESSURE WASHER AT THE END OF THE LANCE.?WITH THANKS AUSTIN GIBBONS
➡️ Reply
#K.E.W by Serge on 2013-06-13 13:06
HelloI have just purchased a KEW 38A2VA power washer with a faulty heater. Is it possible to get a manual and an exploded view drawing over this machine?Thanks!
➡️ Reply
#K.E.W by Gerald Mansfield on 2007-10-01 00:46
I purchased a K.E.W. 1500 unit on a sale and would like to get an owners manual/service manual for it. It\'s an electric unit. Thank you, Gerry Mansfield
➡️ Reply
#K.E.W by mario yasin on 2012-12-04 21:44
i need to fix my pei kew 4503kb pumbe kit and throtecan you fix itthank you
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.