Barco Graphics Service & Repair Forum

I have a Barco monitor that has lost high voltage. The flyback, tripler, and horiz out xistor are probably bad. After receiving the monitor from a customer, who complained of a blank screen, I turned the monitor on and the text came up for about 4 seconds. I heard a small \"pop\" and nothing after that. What are your rates for something like this and how long would it take to get repaired?

— Posted by Barry Sachs on 2010-01-13

Reply🗨️Ask a New Question Below❓

If you need your Barco Graphics unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 3 Comments

#Barco Graphics by Barry Sachs on 2010-01-13 16:51
I have a Barco monitor that has lost high voltage. The flyback, tripler, and horiz out xistor are probably bad. After receiving the monitor from a customer, who complained of a blank screen, I turned the monitor on and the text came up for about 4 seconds. I heard a small \"pop\" and nothi...
Show More
➡️ Reply
#Barco Graphics by Farid on 2018-09-21 02:26
I have a CRT monitor of Aspen Acuson Ultrasound. Its Coil YOK shorted. We need to replace itModel is MCD214A CU MKIIIBarco Display system.Could you fix it?How much?
➡️ Reply
#Barco Graphics by Vincenzo Giobbe on 2019-07-03 10:36
Hi ,can you help me about input signal video monitor MCD214ACU MKIIIbest regards
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.