Calterm Electronics Service & Repair Forum
Hello,I recently changed the battery in my multimeter (66430), and when I turn the dial to 20V DC to measure a battery, I get a \'-1\' display. This display comes up as I turn the dial and before I have plugged in the tester terminals.Please help,Chris
—> Purchase or Repair:
Reply🗨️Ask a New Question Below❓
Recent Comments Search: "Calterm Electronics"
- Calterm Electronics → All can be ↗
- Calterm Electronics → Calterm Electronics toggle switch kit 41210 ↗
- Calterm Electronics → Calterm Electronics Universal Ignition Switch Installation Picture Car ↗
- Calterm Electronics → Calerm 66420 Manual ↗
- Calterm Electronics → Calterm Electronics Datasheet / Specs needed ↗
- Calterm Electronics → Calterm 41210 ↗
- Calterm Electronics → Digital Ohm Meter ↗
- Calterm Electronics → CALTERM #66436 ↗
- Calterm Electronics → Manual ↗
- Calterm Electronics → Calterm Electronics New Multimeter Lead ↗
- Calterm Electronics → Calterm Electronics Ohm meter ↗
- Calterm Electronics → Calterm Electronics Calterm 66430 multi meter error display ↗
- Calterm Electronics → Calterm Electronics Heat shrink tubing ↗
- Calterm Electronics → calterm 66420 manual ↗
- Calterm Electronics → Calterm Electronics Calterm 66474 Digital Engine A ↗
- Calterm Electronics → 66420 Calterm owners manual ↗
- Calterm Electronics → Watch Movies Online ↗
- Calterm Electronics → Best inspiron 530 review quad ↗
- Calterm Electronics → Calterm Electronics Calterm 66474 Digital Engine Analyzer ↗
- Calterm Electronics → Calterm Electronics CALTERM DIGITAL ENGINE ANALYZER 66474 ↗
If you need your Calterm Electronics unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110
Recent 20 Comments
I want to purchase various sizes and Quantities of Calterm Polyolefin Shrink Tubing. Please direct me to the proper venue. This stuff is the BEST!Thank You so much..........Paul
—> Purchase or Repair:
—> Purchase or Repair:
Do you folks have a manual for the use of your ohm meter? If so I would like to obtain one. Thank you
—> Purchase or Repair:
—> Purchase or Repair:
I BROKE THE LCD SCREEN ON MYANALYZER AND WAS WONDERING IF YOU WOULD HAVE A REPLACEMENT FOR IT I TOOK IT APART AND AND IT LOOKS LIKE ONLY 4 SCREWS HOLD IT . SO I WAS WONDERING IF YOU SOLD THIS PART AND IF I COULD PUT IT IN MY SELF OR IS IT SOMETHING THAT NEEDS TO BE DONE AT A SHOP ? IVE HAD IT A LONG…Purchase or Repair: 
...
Show More
Show More
used this to turn on/off fog lights. lights turn on/off but the switch does not illuminate. tried three different switches. what am i doing wrong?wired both light together-grounded to fender and ran hot to accessary center post on switch. ran wire from top post to battery and ran ground wire from bo…Purchase or Repair: 
...
Show More
Show More
1987 Oldsmobile Cutlass Supreme Broughham A picture or sketch of how to install the in dash igniion wiring. How do I get to the wiring?
—> Purchase or Repair:
—> Purchase or Repair:
HelloI am wondering if you have or know where I can find an owners manual for this meter.Thanks Charles Braine
—> Purchase or Repair:
—> Purchase or Repair:
Hello, iown this unit and need to get hold of some kind of owners manual. Can you help??????
—> Purchase or Repair:
—> Purchase or Repair:
Hello!I am with a distributor and my customer is looking for the specs/datasheet for Calterm Electronics 41800.Please email information to mprado@newark.comThank you!MayNewark element14
—> Purchase or Repair:
—> Purchase or Repair:
I would like to have some information on how to use the unit I have. It has the following number on the front just underneath the logo Calterm electronics...66430
—> Purchase or Repair:
—> Purchase or Repair:
I have just purchased a 66430 Multimeter and the common lead wire came out of the probe.It appears the solder was not done correctly.Is therre a way to get a replacement lead from the manufacturer?
—> Purchase or Repair:
—> Purchase or Repair:
I\'m delighted to claim the fact that I\'m the newest participant right here and as i i am looking forward to chatting together with every body throughout here soon.
—> Purchase or Repair:
—> Purchase or Repair:
I have a manual for my Calterm Electronics Calterm 66474 Digital Engine Analyzer that I could copy and mail to you. Sorry, I need to keep the original.
—> Purchase or Repair:
—> Purchase or Repair:
I need the operators manual for the 66420 Caltrem meter. I would appreciate being able to download the manual. I am not able to download from fixya
—> Purchase or Repair:
—> Purchase or Repair:
Hello,I recently changed the battery in my multimeter (66430), and when I turn the dial to 20V DC to measure a battery, I get a \'-1\' display. This display comes up as I turn the dial and before I have plugged in the tester terminals.Please help,Chris
—> Purchase or Repair:
—> Purchase or Repair:
Hello, my boyfriend has this unit and needs to get hold of some kind of owners manual. Can you help??????
—> Purchase or Repair:
—> Purchase or Repair:
HAVE LOST THE SCREW THAT HOLDS THE BACK OF THE METER ON BUT CAN\'T FIND THE RIGHT THREAD SIZE. WHAT IS THIS THREAD SIZE?
—> Purchase or Repair:
—> Purchase or Repair:
Show More