Heimann Service & Repair Forum

We need your repair service support.1) Pls provide us your mailing address and contacts in order to send our unit to you for repair service.2) Send us quotation after inspection of the unit.Your prompt reply is highly appreciated.Thanks,Dorothy Wu

— Posted by Dorothy Wu on 2011-08-06

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Heimann"

If you need your Heimann unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110

Recent 3 Comments

#Heimann by Dorothy Wu on 2011-08-06 03:55
We need your repair service support.1) Pls provide us your mailing address and contacts in order to send our unit to you for repair service.2) Send us quotation after inspection of the unit.Your prompt reply is highly appreciated.Thanks,Dorothy Wu
➡️ Reply
#Heimann by R.M.SHARMA on 2007-12-13 17:54
Microdur harness tester we have sent for repairing to Heimann but it is nor repairable do, help us.
➡️ Reply
#Heimann by Aurelio B. Tormes on 2006-03-20 03:30
We need the following:1. Check/validate if our unit is still Calibrated, it was not calibrated for the past 5 years.2. Do you supply a brass calibration block? what we use is steel calibration block. Our operating cylinder hardness ranges from 180 to 220 vickers, which calibration block is needed fo…...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.