Omniguard Service & Repair Forum

It seems like your Omniguard 4 pressure recorder is not powering on or responding to any commands. This may indicate a possible electrical issue or internal malfunction. The estimated replacement cost for the Omniguard 4 is typically high due to its advanced features, so it's important to have it inspected and repaired by a professional technician

— Posted by John Bain on 2019-01-31

Reply🗨️Ask a New Question Below❓

If you need your Omniguard unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 2 Comments

#Omniguard by RAMP PRAKASH RAI on 2007-05-28 18:08
I have an OmniGuard 540 UV/IR Test Source unit that is malfunctioning. The unit is not emitting any UV or IR light when powered on, and none of the control buttons respond. Despite attempting to troubleshoot the issue by resetting the unit and checking all connections, the problem persists. Based on...
Show More
➡️ Reply
#Omniguard by John Bain on 2019-01-31 18:52
It seems like your Omniguard 4 pressure recorder is not powering on or responding to any commands. This may indicate a possible electrical issue or internal malfunction. The estimated replacement cost for the Omniguard 4 is typically high due to its advanced features, so it's important to have it in...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.