Ondyne Inc. Service & Repair Forum

can you repair a 2000ANNV ? we normally do our own calibration and repairs, but this unit fails calibration and we have not found any data on it. the write up indicates the sensor is not functioning properly and a film was found on the sensor. I should be able to get more information later.can you repair these and what would be an estimate for the repair. we also need information on certifications you have. just looking for information at this time.

— Posted by Mike Collins on 2007-02-13

Reply🗨️Ask a New Question Below❓

If you need your Ondyne Inc. unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 2 Comments

#Ondyne Inc. by Mike Collins on 2007-02-13 14:37
can you repair a 2000ANNV ? we normally do our own calibration and repairs, but this unit fails calibration and we have not found any data on it. the write up indicates the sensor is not functioning properly and a film was found on the sensor. I should be able to get more information later.can you r...
Show More
➡️ Reply
#Ondyne Inc. by Randy Lenox on 2013-04-14 21:23
Hello, I have a model 2100 Ondyne hygrometer with sensor that needs calibration. This instrument is used in a dry/glove box seam sealer. Compared to another hygrometer that just came back from calibration, the ondyne reads about 10°C higher, -45°C compared to -54°C read by the KAHN Cermet II that i ...
Show More
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.