Pelco Service & Repair Forum

Powers up but no back light. Completly black. If I place a beam of light to the monitor, I can see the images.What is the estimated cost for repair of OEM (4CCFL) back lightKen

— Posted by Ken Colby on 2010-01-01

Reply🗨️Ask a New Question Below❓

If you need your Pelco unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent 3 Comments

#Pelco by Patrick MacGregor on 2007-02-25 23:29
I have a Pelco DX1004-060 DVR with a bad power supply board (CMP-03-04). Can/do you repair this item? If so, what (roughly) costto repair (or replace, if possible)?Thank you,Patrick
➡️ Reply
#Pelco by Ken Colby on 2010-01-01 06:13
Powers up but no back light. Completly black. If I place a beam of light to the monitor, I can see the images.What is the estimated cost for repair of OEM (4CCFL) back lightKen
➡️ Reply
#Pelco by mike wilson on 2011-07-18 19:28
need t con board for this monitor
➡️ Reply

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.