Powcon Service & Repair Forum
Unit in need of repair Powcon BD103025 industrial unit with a circuit board issue. It's not powering on despite all connections being secure. Looking for expert assistance ASAP.
—> Purchase or Repair:
Reply🗨️Ask a New Question Below❓
Recent Comments Search: "Powcon"
- Powcon → Powcon BD103025 ↗
- Powcon → Powcon PCB board problem ↗
- Powcon → powcon 200 ↗
- Powcon → Parts of repair one welder POWCON 200 SM ↗
- Powcon → Powcon powcon 200 sm ↗
- Powcon → Powcon board ↗
- Powcon → Powcon powcon 300st ↗
- Powcon → Powcon 200 SM Manual ↗
If you need your Powcon unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110
Recent 10 Comments
hello am converting welder from 460 to 230. i located the 3 buss bars. and changed them. i turned on power and power indicator light an fan comes on. but no power to weld with , any info would be great . thanks
—> Purchase or Repair:
—> Purchase or Repair:
Unit in need of repair Powcon BD103025 industrial unit with a circuit board issue. It's not powering on despite all connections being secure. Looking for expert assistance ASAP.
—> Purchase or Repair:
—> Purchase or Repair:
Have not used welder in 30 years worked great thenI tried to use it and it would not weldthe wire feed works okthe only think different I do not have I don\'t have the co2bottle attached question is there a switch connected to the co2 that is keeping it from weldingCould use a little hekpThanksTIM—>…Purchase or Repair: 
...
Show More
Show More
I have a Powcon 200sm with wire feeder. The drive board went bad in the wire feeder, so I replaced it. Now I do not have fire on the mig gun the inch and purge switch do work and when you pull the trigger it does feed wire and the gas solenoid also accuates. There is 28 volts at the connector in the…Purchase or Repair: 
...
Show More
Show More
Nosotros queremos reparar una máquina soldadora POWCON 200 SM.Necesitamos los siguientes repuestos.Cant # de denominación01 PC BOARD ASSY 105019 REV01 BUS 300v GMQ 3.2/1004 U.K. 919000-3 900202 900000-001ADEMÁS NECESITAMOS UN DIAGRAMA DE CIRCUITOS ELECTRICOS, que tenemos dificultades con su instalac…Purchase or Repair: 
...
Show More
Show More
—> Purchase or Repair: