Rittenhouse Service & Repair Forum

EVERYTHING WORKS FIND..JUST WANT TO UPDATE OLD UNIT

—> Purchase or Repair: Ticket Image

— Posted by DAVE ROSS on 2007-05-18

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Rittenhouse"

If you need your Rittenhouse unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110


Recent 312 Comments

#Rittenhouse by Galen Beaupre on 2019-06-10 14:27
I have a Rittenhouse Model 526.What would cost to test it?

—> Purchase or Repair:
#Rittenhouse by stan Mc Neely on 2014-02-21 17:39
some ONE TOOK MY 577 Apart, I need a picture of how the Chimes goback on the unitTHANKS

—> Purchase or Repair:
#Rittenhouse by David Hocevar on 2011-12-05 17:56
I have a ritenhouse emerson door chime unit. It just started chimeing for no reason I had to disconnect it to silence it. Now when I hooked it back up nothing happens. Clock doesn\'t work, chimes don\'t work.Model 086331 4 tubed chime It also has a teledcrome syncronis motor. Any hope for it.Thank Y…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Doug on 2011-10-01 20:21
I currently have this unit for sale on ebay. the wiring is simply two wires from the 16v transformer to the appropriate screw terminals on the printed circuit board and then the \"switch leg\" from each door bell button at the doors you are using attached to the corresponding terminal screw as label…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Dale Adams on 2006-05-28 16:30
My unit is in need of repair, can you help ?

—> Purchase or Repair:
#Rittenhouse by Bob Przybylski on 2018-11-28 01:06
I have a Rittenhouse door bell model c8355 and the transformer (that is what I think it is) has failed & does nothing but hum. Can I get a new transformer? or can I buy a replacement at the local home depot or Lowes?

—> Purchase or Repair:
#Rittenhouse by Yale Wolff on 2011-03-15 15:01
Have a Rittenhouse intercom system installed in 1956. There appears to be a dead short in the Master.Is there a NuTone Master AM/FM which will work with the satellite room units?

—> Purchase or Repair:
#Rittenhouse by paul caley on 2010-10-09 16:33
plungers have stopped (tried lube) is model w clock can they be replaced by myself or must this be done by a pro or can the entire panel be more easily replaced thank you

—> Purchase or Repair:
#Rittenhouse by craig cipriani on 2011-11-03 15:22
I hav a door chime and clock rittenhouse model 631 and 632 i need a wiring diagram for. any help i can get is appriciated thank you

—> Purchase or Repair:
#Rittenhouse by Irene Shefts on 2018-04-25 21:04
Model# S7808. The detector has been making loud clicks, usually two at a time. What does this mean? Replace it or cleaning. Please help very annoying.

—> Purchase or Repair:
#Rittenhouse by Marcy Berry on 2011-03-03 21:25
I am a property manager who manages a townhome with a broken Rittenhouse intercome system. The speakers on the exterior are installed in the brick so to remove them is a huge project. The main console in the kitchen is what I am looking to repair or replace. The model number is: (looks like) M7034. …Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by DeLane Smith on 2008-09-16 13:35
I need a address to send this unit to get it repaired

—> Purchase or Repair:
#Rittenhouse by Sharon on 2016-11-27 00:16
we have an old rittenhouse intercom system. the units look old but still works fairly well. need information on how to update system. we're remodeling in some areas and would like to check out updating units. don't have specs on the system. not sure of specs but Name on the system is Ritte…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Franklin D Bamsey on 2011-08-22 12:52
Push the outside button and the bell does not work. It has been in the house since it was build in 1988. Any suggestions?

—> Purchase or Repair:
#Rittenhouse by Theresa Perkins on 2008-12-16 16:21
I would like to install my RC633 which I removed from my old house. Can you send me instructions? Thank you.

—> Purchase or Repair:
#Rittenhouse by Larry M Biviano on 2008-11-21 02:47
have hooked up several ways appear to only chime once as if wired for back door.clock woriks fine, does ot chime on all tones

—> Purchase or Repair:
#Rittenhouse by patrick stark on 2013-12-05 15:48
need wiring, replacement parts and pic of the model noted above. front door pushbutton lights, but no response from chime unit. the backdoor is working normal one chime. What may be wrong? the unit has a selector switch to scroll thru various chimes.

—> Purchase or Repair:
#Rittenhouse by Bradley Lowe on 2015-12-05 21:41
HelloIt came with the house had a ele.and he had no luck with repair

—> Purchase or Repair:
#Rittenhouse by Don Heeter on 2017-01-17 21:38
Dear Sirs, I have a Model RM-2.It was put in when the house was built in 1966.It does not work.Thank you for your help.

—> Purchase or Repair:
#Rittenhouse by Maryellen Boudria on 2009-07-19 19:15
I have a Rittenhouse chime Model #410 with it\'s companion two chime on second floor of our 1927 home. The door bell chime works however we are not getting all chimes to work. Only two tones downstairs. Can this be repaired? Please advise.Also, can you tell me how old this model of Rittenhouse is?Ma…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by ellen wright on 2019-03-18 14:12
who repairs or work on the old Rittenhouse intercom systems.I would like to do an upgrade. Since I already have holes in the wall from the old Rittenhouse. I would like to upgrade to something along this same size.

—> Purchase or Repair:
#Rittenhouse by Starla Irvin on 2022-03-20 00:17
Moved in 3 years ago the AM/FM worked but nothing else. Wondering if I could get an estimate

—> Purchase or Repair:
#Rittenhouse by Adrian Younger on 2008-07-08 00:43
Hello. I have an Emerson-Rittenhouse Door Chime Model RC577 and it has quit working. I was wondering if there is a replacement transmitter available for this chime. It has the motor attached to the transmitter so I don\'t htink I can get a replacement at a store. Any information you could give me wo…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Diane Reichard on 2010-04-14 13:54
Hello! Do you have any parts for Rittenhouse (Emerson) All Transistor Radio-Intercom System, Model RM-1 (AM radio) or RM-2 (AM/FM radio)? Our system dates from the 1960\'s--still going strong. But I need knobs and especially the instruction manual because I don\'t know how to answer and use the exte…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Oscar Soltero on 2015-08-15 17:20
Hello, I am inquiring about part number Rittenhouse C8578-1 135-7351-01, which seems to be a door chime. My client is experiencing issues with it and would like further information on how to address the problem. Thank you for your assistance.

—> Purchase or Repair:
#Rittenhouse by Eric Hoffman on 2007-12-23 04:40
I have just recently purchased a house that has a Rittenhouse Model 7300 Intercom system that does not work. I am trying to find a schematic for it. I know that it is an old system, but would like to use it to monitor my young children. Any help would be appreciated.Thank you.Eric Hoffman—> …Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by ann chamberlin on 2010-03-07 15:43
Jennifer Walker:Did you ever figure out what to do about replacing your Rittenhouse unit? I\'m in the same boat!Any ideas or products you have come across on your own would be appreciated

—> Purchase or Repair:
#Rittenhouse by Corinne Censulla on 2012-02-29 17:56
I have a very old doorbell/ clock combination. The Model # is 450. The chimes work but not the clock. Since it is installed into the wall is there one the will replace using the same insert?

—> Purchase or Repair:
#Rittenhouse by Ray Smith on 2011-11-29 00:44
very low sound no door chime

—> Purchase or Repair:
#Rittenhouse by Michael Senay on 2011-09-08 17:07
My rittenhouse chime is about 15 years old and I would like to get it repair. I would like to know who can repairs it.

—> Purchase or Repair:
#Rittenhouse by Richard Gilbert on 2014-03-13 02:02
Looking to replace the outside door bell speaker Mod. No.M9305

—> Purchase or Repair:
#Rittenhouse by Earl Miller on 2012-10-11 01:03
Can I use the existing wiring and recessed wall areas of the old system listed above with a new replacement system. If so, what new updated system will work? Thanks

—> Purchase or Repair:
#Rittenhouse by Morris Hoagland on 2014-01-05 03:53
My Rittenhouse Master unit has failed. Is there a replacement unit I can purchase?

—> Purchase or Repair:
#Rittenhouse by william junker on 2010-03-20 16:08
I need a replacement part for this devise.

—> Purchase or Repair:
#Rittenhouse by Michelle NEWBY on 2009-05-20 00:04
Wee have an Emerson Rittenhouse doorbell model #RC552-1. The motor has fried itself. Can you repair? Thank you. H - (805) 685-2317

—> Purchase or Repair:
#Rittenhouse by Frank Spramelli on 2015-02-10 19:04
needs repaired tuning dial is broken.

—> Purchase or Repair:
#Rittenhouse by Mark Danko on 2015-09-10 19:17
Hi, need repair to this unit, sound cuts in and out when volume control knob is turned/wiggled. Moving molex 5 pin connector on circuit board also causes power to cut in and out. Mode delector knob has become stiff to operate. Please send estimate if repair is possible, thanks

—> Purchase or Repair:
#Rittenhouse by Jim Fields on 2012-11-19 16:03
I have a schematic for Models M7010, M7011, M7012, M7020. The document also has AM Alignment, FM Alignment, Troubleshooting chart, and list of replacement parts for printed circuit board.

—> Purchase or Repair:
#Rittenhouse by sue wardy on 2010-02-22 15:07
static, fade in and out radio. intercom doesn\'t work but don\'t care about that just want the fm on radio to work more consistently

—> Purchase or Repair:
#Rittenhouse by Howard Hendricks on 2009-07-12 04:29
I have a Rittenhouse Chine door bell with four long poles. The model number is c8578-1, The unit will not work, I noticed two bad diodes, and removed them I am having problems locating the right ones. Is this something you can fix?

—> Purchase or Repair:
#Rittenhouse by George Buffington on 2006-06-01 00:00
Can the Rittenhouse C8203 doorbell be repaired or purchased as a replacement? I'm trying to check this off my to-do list. Thank you!

—> Purchase or Repair:
#Rittenhouse by Joseph LaBarbera on 2012-06-11 14:33
Would like to know if there is a replacement for this unit or where I can find a replacement knob for the Talk Listen stalk.

—> Purchase or Repair:
#Rittenhouse by randy connelly on 2010-04-12 00:59
I need a Rittenhouse door bell botton part number C8000. Is this womethign you may have?

—> Purchase or Repair:
#Rittenhouse by Angela on 2015-11-22 00:03
i am looking for the cover of the door chime for the above model that needs replacing.

—> Purchase or Repair:
#Rittenhouse by Jim Drouillard on 2008-05-16 02:50
I have the above mentioned door chime (Rittenhouse door chime model C8536) that does not work correctly. There where some broken wires from the transformer coils that I soldered back on and now it does not work correctly. Do you have a schematic for this unit?

—> Purchase or Repair:
#Rittenhouse by Bob Murley on 2014-10-31 04:57
Is the volume of the chime adjustable?

—> Purchase or Repair:
#Rittenhouse by Barb C on 2009-03-27 12:35
Same as James Mann note - have 1970\'s Rittenhouse intercom---can we replace old system - can we purchase new units but use same wiring??

—> Purchase or Repair:
#Rittenhouse by Jeff Swiger on 2009-12-09 21:38
I would like to replace my working existing RMC-4 rittenhouse intercom with a compatible unit. While using the existing wires? Suggestions _ and would you be interested in the old unit and speakers - 8 + 1 doorThanks,

—> Purchase or Repair:
#Rittenhouse by Kathryn Fenich on 2007-12-18 20:21
Rittenhouse Solid State AM/FM radio intercom system for house and outdoors

—> Purchase or Repair:
#Rittenhouse by Hal Hester on 2016-07-09 23:01
Similiar issue, my doorbell kept sticking. So I replaced the sticky button but now my springs inside the bell housing seem to be sprung and unable to move the plunger the full range to ring or retract.

—> Purchase or Repair:

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.