Hello There,This is Shem Santos, Mark Process Engineer of Amkor Technology Philippines. Would like to ask for your expert opinion in our quest to improve TPC 261 cure time from 1.5 Hrs to 1 hr. Out current temperature setting is 110 degrees celcius.If ever I opted for 1 hr for faster cycle time do i need to increase the mark cure temperature? Will this have an effect on the solderabitity? Pls advise ASAP.regards,Shem
If you need your Tecaprint unit tested or repaired,
give us a call at 1-336-969-0110.
Estimates are free with an approved repair. Declined or unrepairable units are subject to a $75 evaluation, handling, and standard return-shipping fee. Extended warranties may be available.
Shipping/Receiving:
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
Phone: 1-336-969-0110
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
🚑 Rush repair shipments only — no walk-ins.
Industrial Electronic Repair
124 Five Forks Dr PMB #208
King, NC 27021
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.
Show More