Rittenhouse Service & Repair Forum

Removed outer casing - now doorbell doesn't work - noticed loose redwire - where do I attach?

—> Purchase or Repair: Ticket Image

— Posted by Gord Sweatman on 2017-09-01

Reply🗨️Ask a New Question Below❓


Recent Comments Search: "Rittenhouse"

If you need your Rittenhouse unit tested or repaired,
give us a call at 1-336-969-0110.
We offer free estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110


Recent 312 Comments

#Rittenhouse by Lynn Villano on 2011-05-06 13:29
but want door bell to continue working. Can we get wiring schematics?

—> Purchase or Repair:
#Rittenhouse by P. Markworth on 2014-01-17 18:45
Do you know of anyone in Central or East Central Ohio who can repair a Rittenhouse electric door chime? It has four, short brass tubes and chimes like The Westminister chimes. Thank you.

—> Purchase or Repair:
#Rittenhouse by FLORENCE LUM on 2010-01-22 03:42
Is there someone in Honolulu, HI whom I can contact to test and repair my intercom, and replace my ON/Off switch @ the MASTER SPEAKER?We have enjoyed our unit for many years, since 1968.

—> Purchase or Repair:
#Rittenhouse by Qaiser Baig on 2012-07-01 04:25
Hi,Some one open the wires of my door bell Model C8550 (in the bell). Would you please give the wiring/connection diagram for this door bell so that I can re-connect the wire to operate my door bell.You co-operation & early response will be highly appreciated.Regards,Qaiser Baig—> …Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Arturo nunez on 2015-03-23 00:25
the Rittenhouse C8578-1 135-7351-01 door chime is down. Need someone to check it out tomorrow. Thanks!

—> Purchase or Repair:
#Rittenhouse by Debbie Solovey on 2014-10-25 01:56
Hello, I am living in the house I grew up in and all of a sudden I noticed thatthe front doorbell was not working. The side doorbell hasn\'t worked for a long time. I have done some research so I will give you the information I have.Nutone Chime Signal, made in USA 1952, Model K 26 902 or 002It is a…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Bradley Lowe on 2015-12-05 21:41
HelloIt came with the house had a ele.and he had no luck with repair

—> Purchase or Repair:
#Rittenhouse by ElectraChime on 2017-01-22 03:43
I can make new bells for this chime. See my sites: doorbellmuseum.org and electrachime.comBestRobert

—> Purchase or Repair:
#Rittenhouse by Tony Falco on 2012-04-17 19:38
Do you have available a manuel for the emerson ritterhouse RCM-4 intercom. I have to re- install mine

—> Purchase or Repair:
#Rittenhouse by macgretz on 2017-04-19 20:58
I have a Rittenhouse Emerson Elec Model C8326 (perhaps 1960's) that has stopped working today. The chimes and housing seem okay, but the mechanism and bell button are old and worn out. Do you have replacement parts - and at what cost?

—> Purchase or Repair:
#Rittenhouse by Steve on 2011-05-01 18:27
need diagram for wiring of C8203. Only two reds, 2 whites, where would transformer lead be?

—> Purchase or Repair:
#Rittenhouse by Bob Przybylski on 2018-11-28 01:06
I have a Rittenhouse door bell model c8355 and the transformer (that is what I think it is) has failed & does nothing but hum. Can I get a new transformer? or can I buy a replacement at the local home depot or Lowes?

—> Purchase or Repair:
#Rittenhouse by Eddie Rodriguez on 2019-10-13 21:47
I have a Master Model 631 & 632, The clock stop working. its showing the red dot on the face of the clock that indicates power failure. The chimes still work fine with no issue. Can you provide instruction on how to test and/or repair. Thank youEddie

—> Purchase or Repair:
#Rittenhouse by Gregory Luchey on 2017-03-26 21:44
Door Bell repair motor needed

—> Purchase or Repair:
#Rittenhouse by Ejschreier@hotmail.com on 2015-03-25 11:15
Lost during remodeling.

—> Purchase or Repair:
#Rittenhouse by jimmy jamison on 2008-04-08 19:34
we have modle m7035 the door bell and gate buzzer in still workes but the talk butten and volumne dose not. would like to fix or replace unitplease help thank you

—> Purchase or Repair:
#Rittenhouse by Candy Cicoria on 2011-07-14 01:45
I recently moved into a house that has the Rittenhouse All Transistor RCM-1 system in every room. It\'s obvious this system has not worked in a few years, but I want to repair it and keep it with the time of the home. A newer system would take away from it\'s appeal. Is there anyone in the Tulsa, OK…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Jim Drouillard on 2008-05-16 02:50
I have the above mentioned door chime (Rittenhouse door chime model C8536) that does not work correctly. There where some broken wires from the transformer coils that I soldered back on and now it does not work correctly. Do you have a schematic for this unit?

—> Purchase or Repair:
#Rittenhouse by Kathy Grant on 2018-09-24 16:43
I recently purchased an older home that has a Model # RC-475 - 16 volt door chime that works fine, but lacks the cover. Is it possible to purchase just a cover from you or is something like this no longer available. Amazon has one but the mfg. dimensions wouldn't fit. As close as I can measure …Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Jennifer Walker on 2009-04-26 01:22
I have read several threads asking about updating an old Rittenhouse system. I would like to do the same, hopefully avoiding the need to replace drywall, etc., since this system is considerably larger than the Nutone products. I couldn\'t find any responses addressing whether or not there were solut…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Anthony Butts on 2011-10-02 19:14
The unit works, but possibly in need of some service. The AM radio works , but no FM. There is a bit of background noise in the system.

—> Purchase or Repair:
#Rittenhouse by Theresa Perkins on 2008-12-16 16:21
I would like to install my RC633 which I removed from my old house. Can you send me instructions? Thank you.

—> Purchase or Repair:
#Rittenhouse by arnny on 2009-04-14 22:14
I need a power suply for my Emerson-Rittenhouse model RC 633

—> Purchase or Repair:
#Rittenhouse by GALLAGHER on 2025-04-27 13:41
Drive or board failure on Rittenhouse M7012 intercom/radio. Needs immediate attention to avoid disruption. Heading to next location now.

—> Purchase or Repair:
#Rittenhouse by Ray G. Brubaker on 2017-09-11 14:32
I have a model Rittenhouse # E780DC door bell push button. The center plastic button is broken. I need a replacement . I can use the whole assemblyPlease email me as to where I can buy it. Thank you.

—> Purchase or Repair:
#Rittenhouse by STEVE on 2013-10-30 16:58
where can i find a schematic for a rittenhouse rm-20/22 intercom am fm radio

—> Purchase or Repair:
#Rittenhouse by David Hocevar on 2011-12-05 17:56
I have a ritenhouse emerson door chime unit. It just started chimeing for no reason I had to disconnect it to silence it. Now when I hooked it back up nothing happens. Clock doesn\'t work, chimes don\'t work.Model 086331 4 tubed chime It also has a teledcrome syncronis motor. Any hope for it.Thank Y…Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by Mark Danko on 2015-09-10 19:17
Hi, need repair to this unit, sound cuts in and out when volume control knob is turned/wiggled. Moving molex 5 pin connector on circuit board also causes power to cut in and out. Mode delector knob has become stiff to operate. Please send estimate if repair is possible, thanks

—> Purchase or Repair:
#Rittenhouse by James Short on 2013-02-24 20:40
A plunger on my 50 year old door chime is not returning to the rest position when the door chime is not activated. The consequence is a continuous buzz and erratic operation when the button is pressed.Have I provided sufficient information to diagnose the ease of repair?Thank you.Jim—> …Purchase or Repair: Ticket Image...
Show More
#Rittenhouse by tom roegner on 2008-09-26 22:07
Eight chime unit {552} repeats sequence continually until switch is disconnected. Switch has been replaced but problem continues----any ideas and is it repairable.....

—> Purchase or Repair:
#Rittenhouse by Robert King on 2010-08-02 01:52
I know this chime assembly is very old but is there a replacement kit for the hammers. they are sticking and perhaps the springs are just too soft. I\'d appreciate any help you can give me.

—> Purchase or Repair:
#Rittenhouse by Paul on 2016-09-11 18:49
Are you able to repair it?

—> Purchase or Repair:
#Rittenhouse by Bil Hoag on 2015-11-11 17:58
Installed in 1987 when we built the house. Has begun sporadic multiple, single dings, all hours, day and night. I have replaced, back up battery and fuse in motor. Now makes a fairly loud buzzing sound also. Thoughts?

—> Purchase or Repair:
#Rittenhouse by DAVE ROSS on 2007-05-18 16:21
EVERYTHING WORKS FIND..JUST WANT TO UPDATE OLD UNIT

—> Purchase or Repair:
#Rittenhouse by Jessica Rasmussen on 2010-07-17 03:18
I get typically one of three chimes to sound when the doorbell is rung, occassionally 2 followed by a buzzing sound. Some of the wires were loose and I tightened them, but still don\'t get all the tones. Any ideas on what to do to get all three chimes to ring?

—> Purchase or Repair:
#Rittenhouse by vera price on 2009-07-29 12:53
I have a door bell Model C8229 that started to make a ringing sound. It looks as if the plates are vibrating.

—> Purchase or Repair:
#Rittenhouse by Earl Miller on 2012-10-11 01:23
Is there a new updated unit (with new bells & whistles) that can use the existing wiring and wall recesses of the old units. If so, where can I get them and what would be a ballpark pricing? Thanks

—> Purchase or Repair:
#Rittenhouse by Robin Campbell on 2017-09-10 05:21
I have a Rittenhouse master model 550 and 551 doorbell to be tested and repair if needed.

—> Purchase or Repair:
#Rittenhouse by Franklin D Bamsey on 2011-08-22 12:52
Push the outside button and the bell does not work. It has been in the house since it was build in 1988. Any suggestions?

—> Purchase or Repair:
#Rittenhouse by sal on 2018-01-16 16:43
Trying to obtain new springs and strikers/drivers

—> Purchase or Repair:
#Rittenhouse by Jim on 2008-12-29 15:59
Are there any Emerson Rittenhouse intercom main stations from the mid-sixties available?

—> Purchase or Repair:
#Rittenhouse by john rohter on 2011-03-03 21:43
Looking for instruction for the door chime opporation.

—> Purchase or Repair:
#Rittenhouse by Charles Rose on 2009-12-22 23:34
Need base station repaired. Would purchase old

—> Purchase or Repair:
#Rittenhouse by Eric Zetterberg on 2011-02-11 19:49
I have three doorbells connrcted to chimes but only one works, any suggestions?

—> Purchase or Repair:
#Rittenhouse by radu munteanu on 2022-04-20 17:35
Good day, I would need the wiring diagram for a Rittenhouse Clock Model 631/632. Just saved the clock from our old house before remodel and we want to install it back with a running clock and the chime.Thank youRadu 650-450-4806

—> Purchase or Repair:
#Rittenhouse by Deborah Braid on 2009-12-14 16:48
I have an old rittenhouse 7021 (I think) it is from 1978. It needs a new from cover and the dial to change the stations doesn\'t work. Otherwise it works. Can it be fixed and about how much?

—> Purchase or Repair:
#Rittenhouse by Patsy Goodwyn on 2014-09-27 23:39
We need to replace the long tubes on these chimes. They are look bad and we have lost one of them. Do you have the 4 tubes to replace the old ones with? If so, how much are they? Patsy

—> Purchase or Repair:
#Rittenhouse by Mark on 2017-09-04 20:48
I'm looking for a replacement circuit board for a Rittenhouse model C8538. Please let me know where I can purchase one.

—> Purchase or Repair:
#Rittenhouse by karen varel on 2011-09-07 00:53
Do you sell parts for rittenhouse dooor chimes specifically Model #C8550 or do you know where I can get them?

—> Purchase or Repair:
#Rittenhouse by Michelle NEWBY on 2009-05-20 00:04
Wee have an Emerson Rittenhouse doorbell model #RC552-1. The motor has fried itself. Can you repair? Thank you. H - (805) 685-2317

—> Purchase or Repair:

Contact Us

🚑Shop Location🛠️

Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
🚑 Rush repair shipments only — no walk-ins.

📞Phone

1-336-969-0110

📦Mailing Address🚛

Industrial Electronic Repair
931-E S. Main St #204
Kernersville, NC 27284
📦 Mailing Address (for invoices or shipped repairs)
No walk-ins accepted.